Epson TM-H6000 Manuel - Page 7

Parcourez en ligne ou téléchargez le pdf Manuel pour {nom_de_la_catégorie} Epson TM-H6000. Epson TM-H6000 13 pages. How to connect printer with a wireless adapter
Également pour Epson TM-H6000 : Brochure (1 pages), Manuel de l'utilisateur (15 pages), Spécifications (2 pages), Manuel de l'utilisateur (15 pages), Manuel d'instructions (12 pages)

Imprimer la page

How to connect an Epson POS printer with Ethernet Interface

(Key: 2-7 On: refers to the switch number 7 is turned On)

Confirm the initial settings of the Printer

Run the printer self test (hold down the feed button while turning on the printer). The printer will print a list of initial settings

including interface type and buffer capacity. Verify that the interface is "serial" for this type of Ethernet adapter.

Quick Test Printout, Type II Adapter

To get a configuration / status report with information about the printer and Ethernet module, along with maintenance

counts and settings, do the following:

for PRINTERS with Cover Sensor

Power the Printer up, with Ethernet Module installed .

Pop the receipt printer cover

Press the FEED button

Close the receipt printer cover

NOTE:

printout will indicate an UNKNOWN PRINTER. If this happens, cycle power, and wait for the Green LED to

start blinking. - With the module connected to a Ethernet, this delay will be shorter than if there is no

Ethernet connected and the modules spends longer looking for one.

for PRINTERS without Cover Sensor

With a powered OFF module

Set Dip-Switch 1 (on the module) to ON

Power up the unit

Status Report will print

http://www.beaglehardware.com/howtoethernet.html[3/4/2011 12:27:20 PM]

Wait for the green LED on the module to start blinking! If you proceed with this too quickly, the

Printer

Sale!

TM-U220

$129

TM-U295

$184

TM-U375

$199

TM-

U675

$199

TM-

H6000III

$349

TM-T88II

$109

TM-T88III

$139

TM-T88IV

$199

TM-T88V

$259

New

TM-U200

$99