Epson TM-L90 series Manuel de l'utilisateur - Page 10

Parcourez en ligne ou téléchargez le pdf Manuel de l'utilisateur pour {nom_de_la_catégorie} Epson TM-L90 series. Epson TM-L90 series 17 pages. Attaching cover on the power switch
Également pour Epson TM-L90 series : Brochure (1 pages), Brochure (2 pages), Spécifications (2 pages), Spécifications (8 pages), Manuel d'information (5 pages), Spécifications (4 pages), Commencer ici (2 pages), Commencer ici (2 pages), Manuel (13 pages), Manuel d'instructions (12 pages), Manuel (2 pages)

English

Make sure that the mode switch is set to the mode you are going to use.

(To the right for the label peeler issuing mode, or to the left for the label

continuous issuing mode.)

Pull out the paper until the end exactly reaches the guideline (indicated with

arrows) shown in the illustration below. Eliminate any slack in the roll paper,

and then close the roll paper cover.

Note:

Making sure the paper end is at the guideline reduces the number of labels required

for detecting the minimum paper length. The number of labels issued depends on the

length of the label, but 2 labels are issued when the length of the label is less than

50 mm {2"}, and 1 label is issued when it is 50 mm {2"} or more.

After the paper is automatically fed and the first label comes out, the

PAPER OUT LED starts flashing.

6 TM-L90 with Peeler User's Manual

Left: label continuous

issuing mode

Right: label peeler

issuing mode