Epson ChromaBlast 1.0 Manuel du propriétaire - Page 11
Parcourez en ligne ou téléchargez le pdf Manuel du propriétaire pour {nom_de_la_catégorie} Epson ChromaBlast 1.0. Epson ChromaBlast 1.0 13 pages. For epson stylus pro 4880
Également pour Epson ChromaBlast 1.0 : Manuel de démarrage (47 pages)
Imprimer la page
Follow these steps to replace the lamp:
1. Press the P
button to turn the projector off, then
Power
wait for the P power light to stop flashing.
2. Unplug the power cord and disconnect any cables.
3. If the projector has been on, let it cool for at least one hour.
4. Turn the projector upside-down. Push in the tabs on the
lamp cover and push it up to remove it.
5. Use a small screwdriver to loosen the two screws securing the
lamp; you can't remove the screws.
6. Grasp the lamp as shown and pull it straight out.
EPSON PowerLite Home 10 Projector
7. Carefully insert the new lamp and tighten the retaining
screws.
8. To replace the lamp cover, insert the tabs and then snap the
cover into place.
Note: Make sure the lamp cover is securely fastened. The
warning light flashes and the projector lamp won't turn on if
the cover is open.
After replacing the lamp, you need to reset the lamp timer, as
described in the next section.
Resetting the Lamp Timer
After you install a new lamp, you need to reset the timer so the
projector can keep track of how many hours it has been used.
Note: Reset the lamp timer only after you install a new lamp. If you
reset it at any other time, the projector will not indicate the correct
number of lamp usage hours.
Follow these steps:
1. Make sure the power cord is connected to the projector and
to an electrical outlet.
2. Turn on the projector and wait for it to warm up.
3. Press the
button on the projector or remote control.
Menu
You see the main menu.
4. Select the
menu. You see the lamp usage hours and
Reset
other settings.
5. Select
Lamp Hours Reset
6. When you see a prompt asking whether you want to execute
the command, highlight
7. When you're finished, press
The lamp usage timer doesn't register until you've used the
lamp for at least 10 hours. After that, the timer updates lamp
usage in one hour increments.
7/03
EPSON PowerLite Home 10 Projector - 11
.
and press the
button.
Yes
Select
or
.
Esc
Menu