If projecting onto a
blackboard or wall
Sales by branch for January–February period
60
60
60
January sales
February sales
52
50
Sales targets
50
48
50
43
40
40
40
38
36
38
30
31
30
29
30
20
20
20
10
10
10
0
0
0
Sapporo
Tokyo
Nagoya
Osaka
Fukuoka
NewYork
ShangHai
Sapporo
January sales February sales Sales targets
Total
January sales February sales Sales targets
Sapporo
50
48
38
136
Sapporo
50
48
Tokyo
23
19
52
94
Tokyo
23
19
Nagoya
11
18
29
58
Nagoya
11
18
Osaka
13
32
43
88
Osaka
13
32
Fukuoka
24
22
36
82
Fukuoka
24
22
NewYork
10
17
31
58
NewYork
10
17
ShangHai
33
28
48
109
ShangHai
33
28
Total
164
184
277
625
Total
164
184
Turning the projector off
Turn the power off
for the equipment
that is connected to
the projector.
Press the
twice to turn the
power off.
Set the [R/C] switch
to "OFF".
Wall Shot
Images can be automatically corrected and projected without loss of original colour onto surfaces which
are not white. In addition, the tints can be adjusted in accordance with the brightness of the room.
Sales by branch for January–February period
60
January sales
February sales
52
Sales targets
50
48
43
40
36
31
29
30
20
10
0
Tokyo
Nagoya
Osaka
Fukuoka
NewYork
ShangHai
Total
38
136
52
94
29
58
43
88
36
82
31
58
48
109
277
625
When the projector's power is turned off, images will be projected next time with the status set to
"Wall Shot OFF". If projecting in the same location as before, press the
project images using the previous adjustment values without needing to repeat the measurements.
The status will change in the order "Wall Shot OFF"
each time the
button
If not using for a long period, disconnect the power cable from the electrical outlet.
1. Press the
button.
The current status is displayed on the screen.
2. Press the
button while the status is displayed to change it to "Wall
Shot ON".
Colours in the order red → green → blue → black will be projected for
approximately five seconds, and then the corrected images will be
displayed.
button is pressed.
(Operation) indicator
Flashes orange * (cool-down in progress/approx. 30 seconds)
→ Lights orange
* Do not disconnect the power cable while the indicator is still flashing
orange, otherwise it may result in errors in projector operation.
If the message "The projector is overheated. Clean or replace the air filter
and lower the room temperature." appears during projection of images,
press the
button to turn the power off and then clean or replace the
air filters.
User's Guide "Cleaning the Air Filters and Air lntake Vent"
User's Guide "Wall Shot"
button twice, you can
→
→
"Wall Shot ON"
"Wall Shot Memory Call"
User's Guide"Turning the Projector Off"
"Replacing the Air Filters"
Imprimer la page