Epson Perfection 3200 Informations sur le produit - Page 3

Using the Transparency Unit

To use the transparency unit, remove the reflective document

mat by grasping the top of the mat and sliding it up gently, as

shown.

remove mat

by sliding it up

Make sure the cable for the tranparency unit is plugged into the

round connector. If not, turn off the scanner, then connect the

cable as shown. You may need to raise the scanner cover and

twist the cable to insert it.

make sure that

the arrow faces

Film has two sides, a shiny base side and a dull emulsion side.

The base side of the film has the film maker's name and film ID

numbers printed on it. Place the shiny base side down.

To scan 35-mm film strips, 4 × 5-inch film, or 120/220 (6 × 9-

cm) film, place the film in the correct holder:

transparency unit

Place the holder with the film onto the scanner. Make sure the

white triangle on the holder points to the upper-right corner of

the scanner's document table.

11/02

EPSON Perfection 3200 Series

35-mm strips

EPSON Perfection 3200 Series - 3

4 × 5-inch and

120/220 (6 × 9-cm)

film