Toshiba 18UFV-E1 Manuel d'installation - Page 7

Parcourez en ligne ou téléchargez le pdf Manuel d'installation pour {nom_de_la_catégorie} Toshiba 18UFV-E1. Toshiba 18UFV-E1 13 pages. Split type indoor unit outdoor unit

Imprimer la page

Installation Place

• A place which provides the spaces around the indoor unit as shown in the

diagram.

• A place where there are no obstacles near the air inlet and outlet.

• A place which allows easy installation of the piping to the outdoor unit.

• A place which allows the front panel to be opened.

CAUTION

• Direct sunlight to the indoor unit's wireless receiver should be avoided.

• The microprocessor in the indoor unit should not be too close to RF

noise sources.

(For details, see the owner's manual)

Remote control

• A place where there are no obstacles such as a curtain that may block the

signal from the remote control.

• Do not install the remote control in a place exposed to direct sunlight or

close to a heating source such as a stove.

• Keep the remote control at least 1 m apart from the nearest TV set or

stereo equipment (This is necessary to prevent image disturbances or

noise interference).

• The location of the remote control should be determined as shown below.

(Side view)

7 m

Reception range

* : Axial distance

Cutting a Hole and Mounting

Installation Plate

Cutting a hole

(Rear piping)

100

(Bottom piping)

100

1. After determining the pipe hole position, drill the pipe hole (∅65 mm) at a

slight downward slant to the outdoor side.

NOTE

• When drilling a wall that contains a metal lath, wire lath or metal plate, be

sure to use a pipe hole brim ring sold separately.

INDOOR UNIT

(Top view)

Remote

control

Remote control

(Side piping)

: Pipe hole (∅65 mm)

Mounting the installation plate and screw position

When the installation plate is directly mounted

on the wall

1. Securely ﬁ t the installation plate onto the wall by screwing it in the upper

and lower parts to hook up the indoor unit.

2. To mount the installation plate on a concrete wall with anchor bolts, use

the anchor bolt holes as illustrated in the below ﬁ gure.

3. Install the installation plate horizontally in the wall.

Installation plate

(Keep horizontal direction)

∅5 mm hole

Clip anchor

(local parts)

CAUTION

Failure to ﬁ rmly install the unit may result in personal injury and property

damage if the unit falls.

• In case of block, brick, concrete or similar type walls, make ∅5 mm holes

in the wall.

• Insert clip anchors for appropriate mounting screws 7.

Floor

Anchor bolt

Projection

15 mm or less

Mounting screw

∅4 mm x 25 s

(Unit : mm)

Wall