Dimplex BF9000 Manuel du propriétaire - Page 9
Parcourez en ligne ou téléchargez le pdf Manuel du propriétaire pour {nom_de_la_catégorie} Dimplex BF9000. Dimplex BF9000 19 pages. Dimplex
Également pour Dimplex BF9000 : Manuel d'entretien (17 pages), Manuel du propriétaire (20 pages), Manuel de dépannage (2 pages), Manuel du propriétaire (19 pages), Manuel d'entretien (18 pages)
Imprimer la page
Fireplace Installation
fireplace in a safe, dry and
dust free location.
4.
Use studs to frame an
opening of 24 ½ inches (622
mm) wide X 18 ¼ inches
(463.6 mm) high X 8 ⅞ inches
(225.5 mm) deep.
!
NOTE: On elevated
installations, the bottom edge
and 1/2" (12.7) up either side will
be easily visible after installation
(Figure 2). This area should
be finished in a manner that is
visually appealing and does not
restrict air flow to the unit.
Option #1 - The power cord can
be lead from behind the trim
and along the wall to an outlet
near the fireplace.
Option #2 - A new outlet can be
installed inside the new frame
construction. Plug the unit into
a 15 Amp/120 Volt outlet. If
the cord does not reach, you
may use an extension cord
rated for a minimum of 1875
Watts.
Option #3 - Hardwire
1.
Wire a dedicated, properly
fused circuit with 120 Volt,
15 Amp rating. Allow up to
eight (8) feet of service cable
for connecting power supply
to junction box on fireplace
when installing after finishing
wall.
CAUTION: Use two
conductor, non-metallic sheath
cable with ground wire (3
wires total) for the incoming
power supply on fireplace
inserts. use appropriate wire
to meet local and national
electrical codes for rated power
consumption.
2.
remove the outer jacket and
strip the individual conductor
from the end.
3.
Loosen the screw securing
the junction box cover and
remove the cover.
4.
Take the cables out from the
junction box, loosen the two
wire twist nuts and remove
the cord set (Figure 3).
5.
Route the power supply wire
through the knockout on
supplied alternative junction
box cover and secure with
a wire clamp (not supplied)
(Figure 4).
6.
Connect the black wire (live)
from the unit to the black wire
from power supply (Figure 4).
7.
Connect the white wire
(neutral) from the unit to the
9