Dimplex BFSL33 Manuel du propriétaire - Page 7
Parcourez en ligne ou téléchargez le pdf Manuel du propriétaire pour {nom_de_la_catégorie} Dimplex BFSL33. Dimplex BFSL33 14 pages. Fireplace
Également pour Dimplex BFSL33 : Manuel d'entretien (19 pages), Manuel du propriétaire (13 pages), Manuel d'installation (19 pages)
Imprimer la page
Operation
!
NOTE: After the unit is
switched from flame and high
heat to another function there
is a 30 second fan delay,
where the fan will continue
running before turning off.
C. "O" Button
Pressing this button at any time
will shut the unit off.
D. 3-Position Switch
switches the operation of the
fireplace between the different
modes of the fireplace:
•
oFF (center): makes the unit
inoperable.
•
mAnuAL (top): All functions
of the fireplace are controlled
by the On and Off buttons as
described above (B, C).
•
rEmoTE (bottom): All
functions of the fireplace are
controlled by the remote
Control.
E. LED Indicators
Depicts which of the three (3)
levels the fireplace is currently
operating at: Level 1 , Level 2
or Level 3
.
F. Voltage Selector Switch
needs to be set to reflect the
incoming voltage to the unit -
115V or 230V.
Resetting the Temperature
Cutoff Switch
should the heater overheat, an
automatic cut out will turn the
fireplace off and it will not come
back on without being reset. It
can be reset by switching the on/
off switch to off and waiting ten
(10) minutes before switching the
unit back on.
CAUTION: If you need to
continuously reset the heater,
disconnect power and call
Dimplex customer service at
1-888-DImPLEX (1-888-346-
7539).
Remote Control
The fireplace is supplied with a
radio frequency remote control.
This remote control has a range
of approximately 50 feet (15.25
m), it does not have to be pointed
at the fireplace and can pass
through most obstacles (including
walls). It is supplied with one
of hundreds of independent
frequencies to prevent
interference with other units.
!
NOTE: Before attempting any
operation with the remote, pull
the plastic insulator strip out
from between the remote casing
and battery cover (Figure 2).
7