Dimplex BLF3451 Manuel d'entretien - Page 8

Parcourez en ligne ou téléchargez le pdf Manuel d'entretien pour {nom_de_la_catégorie} Dimplex BLF3451. Dimplex BLF3451 17 pages.

Imprimer la page

Figure 5

NOTE: If the surface you are using as a work area on is

a finished surface that is prone to scratches (i.e. hardwood

flooring), it is recommended that a protective barrier be

used underneath, (i.e. cloth, cardboard, thick plastic).

5. Proceed to the instructions within this manual relating

to the repair being performed - see Table of Contents

for page number.

6. Once repair is complete, reassemble in the reverse

order as above.

Recessed Mount - Partial In-wall

(Figure 7)

Tools Required: Phillips head screwdriver

CAUTION: Follow "Preparation for Service" instructions

before proceeding.

1. Remove the decorative acrylic ember-bed pieces from

the media tray, which lies along the bottom of the inte-

rior Partially Reflective Glass. A medium sized con-

tainer such as a bucket or a box will be needed to keep

the acrylic ember-bed pieces together.

2. Locate and remove the 4 mounting screws located

approximately 3 inches deep in the space between the

outer and inner casing on the left and right hand side.

There are 2 screws per side, upper and lower going

into a stud. (Figure 7)

CAUTION: The fireplace should be supported while

removing the screws to prevent the unit from falling.

3. Remove the fireplace out of the opening by slightly lift-

ing and pulling forward.

4. Carefully lay the unit down on a solid flat surface with

the front of the unit facing up.

NOTE: If the surface you are using as a work area is a

finished surface that is prone to scratches (i.e. hardwood

flooring), it is recommended that a protective barrier be

used underneath, (i.e. cloth, cardboard, thick plastic).

5. Proceed to the instructions within this manual relating

7.0 in.

(179 mm)

19.4 in.

(494 mm)

32.4 in.

(823 mm)

30.0 in.

(761 mm)

34.1 in.

(867 mm)

to the repair being performed - see Table of Contents

for page number.

6. Once repair is complete, reassemble in the reverse

order as above.

Flush Mount – Complete In-wall

(Figure 8)

Tools Required: Phillips head screwdriver

CAUTION: Follow "Preparation for Service" instructions

before proceeding.

1. Remove the decorative acrylic ember-bed pieces from

the media tray, which lies along the bottom of the interi-

or Partially Reflective Glass. A medium sized container

such as a bucket or a box will be needed to keep the

acrylic ember-bed pieces together.

2. Locate and remove the 4 mounting screws inside the

unit located on left and right side towards the front.

Figure 6

Wall Mounting

Bracket

6.8 in.

(172 mm)

3.8 in.

(95 mm)

(406 mm)

Bottom Support

Bracket

16.0 in.

18.0 in.

(457 mm)