Dimplex BLF50 Manuel d'entretien - Page 8
Parcourez en ligne ou téléchargez le pdf Manuel d'entretien pour {nom_de_la_catégorie} Dimplex BLF50. Dimplex BLF50 19 pages.
Également pour Dimplex BLF50 : Manuel d'entretien (16 pages)
Imprimer la page
!
NOTE: If the surface you are using as a work area on
is a finished surface that is prone to scratches (i.e. hard-
wood flooring), it is recommended that a protective barrier
be used underneath, (i.e. cloth, cardboard, thick plastic).
3.
Proceed to the instructions within this manual relating
to the repair being performed - see Table of Contents
for page number.
4.
Once repair is complete, reassemble in the reverse
order as above.
Recessed Mount - Partial In-wall
(Figure 8)
Tools Required: Philips head screwdriver
CAUTION: Follow "Preparation for Service" instructions
before proceeding.
1.
Remove the 4 mounting screws located approximately
3 inches deep in the space between the outer and in-
ner casing on the left and right hand side. There are
2 screws per side, upper and lower going into a stud.
(Figure 9)
CAUTION: The fireplace should be supported while
removing the screws to prevent the unit from falling.
2.
Remove the fireplace out of the opening by slightly lift-
ing and pulling forward.
3.
Carefully lay the unit down on a solid flat surface with
Figure 8
Mounting Holes
Figure 9
Mounting Holes
8
the front of the unit facing up.
!
NOTE: If the surface you are using as a work area is
a finished surface that is prone to scratches (i.e. hardwood
flooring), it is recommended that a protective barrier be
used underneath, (i.e. cloth, cardboard, thick plastic).
4.
Proceed to the instructions within this manual relating
to the repair being performed - see Table of Contents
for page number.
5.
Once repair is complete, reassemble in the reverse
order as above.
Flush Mount – Complete In-wall
(Figure 10)
Tools Required: Philips head screwdriver
CAUTION: Follow "Preparation for Service" instructions
before proceeding.
1.
Locate and remove the 4 mounting screws inside the
unit located on left and right side towards the front.
There are 2 screws per side, going from the side
panels out into the side of the wall stud that frames the
fireplace. (Figure 10)
CAUTION: The unit should be supported while remov-
ing the screws to prevent the unit from falling.
2.
Remove the fireplace out of the opening by slightly lift-
ing and pulling forward.
3.
Carefully lay the unit down on a solid flat surface with
the front of the unit facing up.
!
NOTE: If the surface you are using as a work area is
a finished surface that is prone to scratches (i.e. hardwood
flooring), it is recommended that a protective barrier be
used underneath, (i.e. cloth, cardboard, thick plastic).
4.
Proceed to the instructions within this manual relating
Figure 10
Wall Surface
Mounting Hole
www.dimplex.com