Epson PowerLite 8300i with EasyMP.net module Manuel d'utilisation - Page 30

Parcourez en ligne ou téléchargez le pdf Manuel d'utilisation pour {nom_de_la_catégorie} Epson PowerLite 8300i with EasyMP.net module. Epson PowerLite 8300i with EasyMP.net module 36 pages. Release of check tool for network projectors v1.00 for windows
Également pour Epson PowerLite 8300i with EasyMP.net module : Manuel de l'utilisateur (42 pages), Manuel d'utilisation (47 pages), Installation rapide (2 pages), Bulletin d'information sur les produits (27 pages), Manuel rapide (20 pages), Liste des pièces (1 pages), Manuel complémentaire (2 pages), Brochure & Specs (2 pages), Manuel de l'utilisateur (1 pages), Bulletin d'information sur les produits (25 pages), Bulletin d'information sur les produits (22 pages), Bulletin d'information sur les produits (28 pages), Bulletin d'information sur les produits (41 pages), Bulletin d'information sur les produits (34 pages), Bulletin d'information sur les produits (28 pages), Bulletin d'information sur les produits (15 pages), Bulletin d'information sur les produits (22 pages), Installation rapide (2 pages)

Epson PowerLite 8300i with
EasyMP.net module Manuel d'utilisation
Using the control functions

Procedures for new timer settings

f
2
When you click "Add", the following window is
displayed and the new timer settings are applied.
At "Operation", you can carry out the operations of turning the
power on and off and switching the input sources, similarly for
the control buttons on the main window. If you set the input
source switching, the projector's power will turn on at the timer
start time even if it is not on at the time. Because of this, it is not
necessary to make two separate timer settings for turning the
power on and switching the input source.
3
After completing the timer settings, click [OK].
The timer settings that have been made will be registered and
they can be checked in the displayed timer list.
TIP
You can enable and disable all of the timer settings that have been
registered. Select "Timer" - "Enable" or "Disable" from the "Tool"
menu.
29