Philips 105S63 Manuel de l'utilisateur - Page 11

Parcourez en ligne ou téléchargez le pdf Manuel de l'utilisateur pour {nom_de_la_catégorie} Philips 105S63. Philips 105S63 46 pages. Crt monitor

Imprimer la page

TECHNICAL SUPPORT (FAQ)

Problem & Question

Power LED is not on

No Plug & Play

Picture is fuzzy

Picture bounces or a wave

pattern is present in the

picture

The power LED is ON

(orange) but there's no video

or no picture

Missing one of the primary

colors (RED, GREEN, or

BLUE)

Philips_manual_

Tuesday, November 18, 2003 3:00:46 PM

Possible Solution

*Check if the Power Switch is in the ON

position

*Power Cord should be connected

*Check if the PC system is Plug & Play

compatible

*Check if the Video Card is Plug & Play

compatible

*Check if the D-15 plug pin of Video

Cable is bent

*Make sure the Monitor Drivers are

installed

*Adjust the Contrast and Brightness

Controls.

*Move electrical devices that may cause

electrical interference.

*Computer Power Switch should be in the

ON position

*Computer Video Card should be snugly

seated in its slot

*Make sure monitor's video cable is

properly connected to the computer.

*Inspect monitor's video cable and make

sure none of the pins are bent.

*Make sure computer is operational by

hitting the CAPS LOCK key on the

keyboard while observing the CAPS

LOCK LED. The LED should either turn

ON or OFF after hitting the CAPS

LOCK key.

*Inspect the monitor's video cable and

make sure that none of the pins are bent.