Toshiba 15V31B Manuel du propriétaire - Page 2

Parcourez en ligne ou téléchargez le pdf Manuel du propriétaire pour {nom_de_la_catégorie} Toshiba 15V31B. Toshiba 15V31B 30 pages. Toshiba colour television owner's manual
Également pour Toshiba 15V31B : Manuel d'entretien (39 pages)

Imprimer la page

This equipment has been designed and manufactured to meet international safety standards but, like any electrical

equipment, care must be taken if you are to obtain the best results and safety is to be assured. So, please read the

points below for your own safety.

consumer products and some points may not apply to the goods you have just purchased.

Air Circulation...

Leave at least 10cm clearance around the television to

allow adequate ventilation. This will prevent the TV

from overheating and consequential possible damage

to the TV. Dusty places should also be avoided.

Heat Damage...

Damage may occur if you leave the TV in direct sunlight

or near a heater. Avoid places subject to extremely high

temperatures or humidity, or locations where the

temperature is likely to fall below 5 C (41 F).

Mains Supply...

The mains supply required for this equipment is

230-240V AC 50Hz. Never connect to a DC supply

or any other power source. DO ensure that the TV is

not standing on the mains lead. In the UK, the fuse

fitted in this plug is 5A, and is approved by ASTA

or BSI to BS1362. It should only be replaced by a

correctly rated and approved type and the fuse cover

must be refitted. IF IN DOUBT PLEASE CONSULT

A COMPETENT ELECTRICIAN.

TO FULLY DISCONNECT THE TV, SWITCH OFF

THE MAINS SOCKET AND REMOVE THE POWER

PLUG.

Do...

DO read the operating instructions before you attempt

to use the equipment.

DO ensure that all electrical connections (including the

mains plug, extension leads and inter-connections

between pieces of equipment) are properly made and

in accordance with the manufacturers' instructions.

Switch off and withdraw the mains plug before making

or changing connections.

DO consult your dealer if you are ever in doubt about

the installation, operation or safety of your equipment.

DO be careful with glass panels or doors on

equipment.

3N70401A/COVER

SETTING UP

For your safety

They are of a general nature, intended to help you with all your electronic

Do not...

DON'T remove any fixed cover as this may expose

dangerous voltages.

DON'T obstruct the ventilation openings of the

equipment with items such as newspapers,

tablecloths, curtains, etc. Overheating will cause

damage and shorten the life of the equipment.

DON'T allow electrical equipment to be exposed to

dripping or splashing or objects filled with liquids,

such as vases, to be placed on the equipment.

DON'T place hot objects or naked flame sources,

such as lighted candles or nightlights on, or close to

equipment. High temperatures can melt plastic and

lead to fires.

DON'T use makeshift stands and NEVER fix legs with

wood screws. To ensure complete safety, always fit the

manufacturer's approved stand or legs with the fixings

provided according to the instructions.

DON'T listen to headphones at high volume, as such

use can permanently damage your hearing.

DON'T leave equipment switched on when it is

unattended, unless it is specifically stated that it is

designed for unattended operation or has a standby

mode. Switch off using the switch on the equipment

and make sure your family know how to do this.

Special arrangements may need to be made for

infirm or handicapped people.

DON'T continue to operate the equipment if you are

in any doubt about it working normally, or it is

damaged in any way – switch off, withdraw the mains

plug and consult your dealer.

DON'T throw your old batteries into a fire, dispose of

them in a designated disposal area.

ABOVE ALL – NEVER let anyone, especially

children, push anything into holes, slots or any

other openings in the case – this could result in a

fatal electric shock.

NEVER guess or take chances with electrical

equipment of any kind – it is better to be safe

than sorry.

7/4/03, 5:14 PM