MSI 612BF Manuel - Page 36

Parcourez en ligne ou téléchargez le pdf Manuel pour {nom_de_la_catégorie} MSI 612BF. MSI 612BF 45 pages. 3d-agp vga / 3d-audio m/b for socket 370
Également pour MSI 612BF : Manuel de l'utilisateur (48 pages)

Imprimer la page

Cannot find or initialize the floppy drive controller. make sure the controller is installed correctly

and firmly. If there are no floppy drives installed, be sure the Diskette Drive selection in Setup

is set to NONE.

Invalid EISA Configuration

PLEASE RUN EISA CONFIGURATION UTILITY

The non-volatile memory containing EISA configuration information was programmed

incorrectly or has become corrupt. Re-run EISA configuration utility to correctly program the

memory.

NOTE: When this error appears, the system will boot in ISA mode, which allows you to run the

EISA Configuration Utility.

KEYBOARD ERROR OR NO KEYBOARD PRESENT

Cannot initialize the keyboard. Make sure the keyboard is attached correctly and no keys are

being pressed during the boot.

If you are purposely configuring the system without a keyboard, set the error halt condition in

Setup to HALT ON ALL, BUT KEYBOARD. This will cause the BIOS to ignore the missing

keyboard and continue the boot.

Memory Address Error at ...

Indicates a memory address error at a specific location. You can use this location along with

the memory map for your system to find and replace the bad memory chips.

Memory parity Error at ...

Indicates a memory parity error at a specific location. You can use this location along with the

memory map for your system to find and replace the bad memory chips.

MEMORY SIZE HAS CHANGED SINCE LAST BOOT

Memory has been added or removed since the last boot. In EISA mode use Configuration

Utility to reconfigure the memory configuration. In ISA mode enter Setup and enter the new

memory size in the memory fields.

Memory Verify Error at ...

Indicates an error verifying a value already written to memory. Use the location along with your

system's memory map to locate the bad chip.

OFFENDING ADDRESS NOT FOUND

This message is used in conjunction with the I/O CHANNEL CHECK and RAM PARITY

ERROR messages when the segment that has caused the problem cannot be isolated.

OFFENDING SEGMENT:

This message is used in conjunction with the I/O CHANNEL CHECK and RAM PARITY

ERROR messages when the segment that has caused the problem has been isolated.

PRESS A KEY TO REBOOT

This will be displayed at the bottom screen when an error occurs that requires you to reboot.

Press any key and the system will reboot.