EPSON Stylus Pro 10600
Control Panel
The control panel includes various lights and a display to
indicate the status of the printer:
Display
Error messages
Message
Light
INK LOW
Ink Out light(s)
flashing
INK OUT
Ink Out light(s) on
NO INK CARTRIDGE
Ink Out light(s) on
WRONG CARTRIDGE
Ink Out light(s) on
INVALID CARTRIDGE
FRONT COVER OPEN
Pause light on
INK COVER OPEN
Pause light on
LOAD ROLL PAPER
Paper Out light on
LOAD SHEET PAPER
PAPER JAM
Paper Out light
flashing
PAPER NOT CUT
Paper Out light
flashing
PAPER NOT STRAIGHT
Paper Out light
flashing
PAPER OUT
Paper Out light on
8 - EPSON Stylus Pro 10600
When your ink or paper runs out or a problem occurs, a
message appears on the display. The lights on the control
panel come on or flash. The following table lists the messages
and includes an explanation and instructions for correcting
the problem.
Explanation
Ink cartridge(s) are nearly empty
(printing continues).
Ink cartridge(s) are empty
(printing stops).
Ink cartridge(s) not installed.
You tried to install the wrong ink
cartridge.
Lower cover is open.
You are replacing the ink
cartridge(s) and the ink
compartment cover is open.
Paper source setting in printer
software is different from
control panel.
Paper has jammed in the printer.
Roll paper was not cut
completely.
Cut paper did not fall off.
Paper was fed into the printer at
an angle.
No paper is loaded.
Paper ran out.
9/02
Response
Replace ink cartridge(s) indicated by Ink Out light(s). See page 10
for instructions.
Replace the ink cartridge(s) indicated by Ink Out light(s). See page
10 for instructions.
Install ink cartridges as indicated by the lights. Make sure you
install the correct Photographic Dye, Archival ink, or UltraChrome
ink cartridges. See page 10 for instructions.
If you are installing ink cartridges for the first time, you must
install the cartridges that came with your printer.
If you are replacing ink cartridges, check the package and product
code. You must use the ink cartridges designed for your printer.
Other cartridges will not work.
Close the lower cover.
Close the ink compartment cover when you are finished replacing
the ink cartridge(s).
Make sure the right paper is loaded and the paper source setting
is the same on the control panel and printer software.
Remove the jammed paper.
Cut the paper manually, then remove the cut paper from the
printer and reload it.
Remove the cut paper from the printer. Reload paper.
Reload paper, making sure the edges are straight and aligned
with the vertical row of holes at the paper exit.
Load paper.
Remove any printouts or paper remaining in the printer and load
more paper.
If the message appears during a print job, reset the printer by
pressing the Pause button for 3 seconds. Then load paper and
resend the job.
Imprimer la page