A wide variety of external equipment can be connected via the sockets located on the side and back of the
television. Whilst all the necessary adjustments and controls for the television are made using the remote
control, the buttons on the left side of the television may be used for some functions.
Switching on
If the standby LED is unlit, check that the mains plug is con-
nected to the power and press the
of the television to switch the television on. Then the LED
lights up blue. If the picture does not appear, press
the remote control; it may take a few moments.
To put the television into Standby, press
control. To view the television, press
ture may take a few seconds to appear. Note: The active
Standby LED may appear for a few moments when the TV
is switched off.
Note: A beeping sound will be heard when the buttons
are pressed. This is normal operation, not a fault.
For energy saving:
Turning the television off at its mains supply, or un-plugging
it, will cut energy use to nearly zero for all televisions. This
is recommended when the television is not being used for a
long time, e.g. when on holiday.
Reducing the brightness of the screen will reduce energy use.
Energy effi ciency cuts energy consumption and thus saves
money by reducing electricity bills.
NOTE: Putting the television into standby mode, will reduce
energy consumption, but will still draw some power.
40BV701B_MB65_[GB]_(IB_INTERNET)_DVB-T_(3910UK)_10073323.indd 18
40BV701B_MB65_[GB]_(IB_INTERNET)_DVB-T_(3910UK)_10073323.indd 18
Controlling the TV
Press the MENU button on the remote control to see the
menus.
button on the left side
The main menu appears as a group of icons each for a menu
option. Press the Left or Right button to select a topic.
on
In sub menu screen mode the menu appears as a list. Press
the Up or Down button to select a topic.
on the remote
To use the options press the Up and Down buttons on the
again. The pic-
remote control to move up and down through them and OK,
Left or Right buttons to select the required choice. Follow
the on screen instructions. The functions of each menu are
described in detail throughout the manual.
Using the Controls and Connections on the TV
Using the control buttons on the front of the TV:
• To alter the volume press +
• To alter the programme position press - P/CH + on the right
side of the TV.
• Press +
use - P/CH + to navigate and +
NOTE: The USB socket has limited functionality, and Toshiba
can take no responsibility for damage to other connected
equipment.
To select an external input, press SOURCE until the appropri-
ate input source is selected.
Please always refer to the owner's manual of the equipment
to be connected for full details.
- 18 -
Using the Remote Control
-.
- buttons at the same to view main menu and
- to change value.
03.10.2011 19:02:06
03.10.2011 19:02:06
Imprimer la page