Epson Stylus Pro 7600 Photographic Dye Ink Manuel de déballage et d'installation - Page 16

Parcourez en ligne ou téléchargez le pdf Manuel de déballage et d'installation pour {nom_de_la_catégorie} Epson Stylus Pro 7600 Photographic Dye Ink. Epson Stylus Pro 7600 Photographic Dye Ink 24 pages. Epson stylus pro 7600: brochure
Également pour Epson Stylus Pro 7600 Photographic Dye Ink : Brochure & Specs (24 pages), Manuel d'information (16 pages), Spécifications (4 pages), Manuel d'installation rapide (34 pages), Informations sur le produit (15 pages), Manuel de référence rapide (11 pages), Garantie (8 pages), Brochure & Specs (8 pages), Brochure & Specs (16 pages), Manuel de référence du produit (28 pages), Mise à jour du manuel (4 pages)

Epson Stylus Pro 7600 Photographic Dye Ink Manuel de déballage et d'installation
Note:
If you use the EPSON UltraChrome ink cartridge,
shake the cartridge gently before installing it.
4. Hold the ink cartridge with arrow mark on the
left side and pointing to the rear of the printer,
and insert it into the slot until the
corresponding Ink Out light turns off.
5. Repeat step 4 for the other six color ink
cartridges.
6. After inserting all ink cartridges into each slot,
set the ink lever in the down position.
7. Close the ink compartment cover.
After installing all seven ink cartridges, the printer
begins charging the ink delivery system and the
Pause light flashes (for about 7 minutes). When the
ink delivery system is charged, the Pause light
stops flashing.
c
Caution:
Never do the following while the Pause light is
flashing; other wise damage may occur:
Turn off the printer
Open the front cover
Set the ink lever in the up position
Move the paper lever to the released
position
Unplug the power cord
14
Loading the Roll Paper
To load the roll paper onto the printer, follow the
instructions below.
1. Slide the movable flange off the end of the
spindle.
2. Place the roll paper on a flat surface so that it
unwinds in the direction shown. Slide the roll
paper onto the spindle and fully onto the fixed
flange.
3. Slide the movable flange back onto the spindle
until it fixes into place in the end of the roll
paper.
4. Open the roll paper cover. Holding the
spindle, fit the left and right ends of the
spindle into the mounting brackets inside the
printer.
Note:
The spindle and mounting brackets are color-coded.
Mount the spindle into the mounting bracket that is the
same color as the end of the spindle.
5. Make sure that the printer is turned on, then
repeatedly press the Paper Source button
until the Roll Auto Cut light comes on.