Epson Stylus Pro 9500 - Print Engine Manuel - Page 12

Parcourez en ligne ou téléchargez le pdf Manuel pour {nom_de_la_catégorie} Epson Stylus Pro 9500 - Print Engine. Epson Stylus Pro 9500 - Print Engine 15 pages. Epson stylus pro 9000: product information

Imprimer la page

EPSON Stylus Pro 9000 series

2. Check the control panel display. Use the + or – button to

select the best aligned row or line for pattern #1. Then press

the Enter button to register the setting.

3. Repeat steps 1 and 2 for each pattern.

If you can't make a consistent choice as you look across the

width of the paper, choose the average or most frequent

number, then print the pattern again. Press

through the patterns until you reach the one you want to

repeat.

4. After you have registered all the patterns, press the

button to exit head alignment mode and return to normal

printer operation.

Transporting the Printer

When you need to ship your printer, you should repack it

using the original box and packing materials. Follow these

steps:

1. First turn off the printer and make sure the print head is in

the home (far right) position. If not, turn the printer back

on, wait until the print head moves to the home position,

then turn off the printer.

2. Remove the following parts:

❏ Ink cartridges

❏ Power cord

❏ Interface cable

❏ Paper hammock

❏ Roll paper spindles

❏ All paper or other media

❏ Optional auto take-up reel (if installed)

After you remove the ink cartridges, store them in separate,

resealable bags.

Caution:

If for any reason the printer will not be level during shipping, a

service technician must drain all ink from the printer before it is

shipped.

3. Make sure the ink cartridge clamps are in the upright

position (closed). Leave the ink compartment cover open.

Use tape to hold the cover and the cartridge clamps in place.

This automatically closes the ink valves.

4. Install the carriage shipping restraint (packaging material).

12 - EPSON Stylus Pro 9000 series

5. Close the ink valve locks on each side of the printer.

to cycle

Enter

Pause

6. Remove the left and right side joint cover plates by

spreading the ends and pulling outward. Keep the cover

plates in a safe place.

7. While holding the printer unit, remove the screws from the

left and right sides. Keep the screws in a safe place.

8. Have four people lift printer unit off of the leg assembly,

using the hand grips. Lift the back of the printer first, tilt it

slightly to the front, then slide it back to remove it.

Warning:

The printer unit weighs approximately 212 lb (96 kg). Always

have four people lift it, using the hand grip areas.

9. Keep the printer level while you move it.

8/00

Open