Philips S line 222S1 Manuel de l'utilisateur - Page 4
Parcourez en ligne ou téléchargez le pdf Manuel de l'utilisateur pour {nom_de_la_catégorie} Philips S line 222S1. Philips S line 222S1 31 pages.
Également pour Philips S line 222S1 : Manuel de l'utilisateur (31 pages), Manuel de l'utilisateur (31 pages)
Imprimer la page
1. Important
the monitor by placing your hand or
fingers on the LCD panel.
•
Unplug the monitor if you are not
going to use it for an extensive
period of time.
•
Unplug the monitor if you need to
clean it with a slightly damp cloth.
The screen may be wiped with a
dry cloth when the power is off.
However, never use organic solvent,
such as, alcohol, or ammonia-based
liquids to clean your monitor.
•
To avoid the risk of shock or
permanent damage to the set, do
not expose the monitor to dust,
rain, water, or excessive moisture
environment.
•
If your monitor gets wet, wipe it
with dry cloth as soon as possible.
•
If foreign substance or water gets in
your monitor, please turn the power
off immediately and disconnect
the power cord. Then, remove the
foreign substance or water, and
send it to the maintenance center.
•
Do not store or use the monitor in
locations exposed to heat, direct
sunlight or extreme cold.
•
In order to maintain the best
performance of your monitor and
use it for a longer lifetime, please
use the monitor in a location
that falls within the following
temperature and humidity ranges.
• Temperature: 0-40°C 32-104°F
• Humidity: 20-80% RH
Important information for Burn-in/
Ghost image
•
Always activate a moving screen
saver program when you leave
your monitor unattended. Always
activate a periodic screen refresh
application if your monitor will
display unchanging static content.
Uninterrupted display of still or
static images over an extended
period may cause "burn-in", also
known as "after-imaging" or "ghost
imaging", on your screen.
•
"Burn-in", "after-imaging", or
"ghost imaging" is a well-known
phenomenon in LCD panel
technology. In most cases, the
"burn-in" or "after-imaging" or
"ghost imaging" will disappear
gradually over a period of time after
the power has been switched off.
Warning
Failure to activate a screen saver, or
a periodic screen refresh application
may result in severe "burn-in" or "after-
image" or "ghost image" symptoms
that will not disappear and cannot be
repaired. The damage mentioned above
is not covered under your warranty.
Service
•
The casing cover should be opened
only by qualified service personnel.
•
If there is any need for any
document for repair or integration,
please contact with your local
service center. (Please refer to
Service contact information listed in
Important information manual.)
•
For transportation information,
please refer to "Technical
Specifications".
•
Do not leave your monitor in a car/
trunk under direct sun light.
Note
Consult a service technician if the
monitor does not operate normally, or
you are not sure what procedure to take
when the operating instructions given
in this manual have been followed.
2