Toshiba T520 Manuel du propriétaire - Page 27

Parcourez en ligne ou téléchargez le pdf Manuel du propriétaire pour {nom_de_la_catégorie} Toshiba T520. Toshiba T520 37 pages. 3lcd data projector

Imprimer la page

Operating a computer using the remote control

A computer can be operated using the projector's remote control. This function is available

on any computer with the Windows 98/98SE, Windows Me, Windows 2000, or Windows XP

OS, that is equipped with a USB port which can support USB1.1 (The mouse remote

control receiver is also supported on OS 9 or OS X for the Macintosh). However, please

note that Toshiba does not guarantee the operation of all computers.

Connecting a computer

Connect the projector to a computer using the supplied USB cable. See Fig. (1) below.

For models equipped with PC card slot, connect the supplied Mouse remote control

receiver to the computer. See Fig. (2) below.

(1)

To USB port

USB

MONITOR

COMPUTER

( Y,P

)

CONTROL

Operating a computer

The mouse remote control function is available when the remote control is set to [PC

Mode]. (See "Switching operation modes"

Point the remote control at the infrared remote sensor (in models using Mouse

remote control receivers, point it at the Mouse remote control receiver), and

operate the remote control's buttons.

G Moving the mouse pointer

Move the pointer control button in the direction that you wish the mouse pointer to

move, then press.

G To left click

Press the L-CLICK button.

G To right click

Press the R-CLICK button.

G To drag and drop

Move the pointer control button in a (L-)clicked state, then when the pointer is over

the desired location, release the button.

G Using the computer's up and down arrow key functions

Press the

and

buttons to switch PowerPoint

Remote Control Front

Pointer control

VOL.-

VOL.+

PJ MODE

LASER

MENU / ENTER

R-CLICK

INPUT

R-CLICK

(2)

To USB port

Mouse remote control receiver

p.20

slides.

Remote Control Rear

L-CLICK

Using the menus

You can call up on-screen menus, and conduct a number of adjustments and settings,

using the operation buttons

p.16

on the control panel (main unit side) and remote control.

I How to use the menus

The menu shown below is only for operation instructions and might be different from

the actual display.

1. Start

2. Select a Category

Select a category by using

There are following four

categorys.

Image adjustment menu

p.54

Default setting menu

p.54

Display setting menu

p.55

PC card setting menu

p.55

Press

of the selected category.

3. Adjustments & Settings

Item

Adjustment/Setting Value

These marks signify the

items can be adjusted/set

by using

These marks signify an

item can be switched by

using

The figure shows a typical example.

As the display may differ depending

on the item, use the following pages

as a reference.

These marks signify the items can be selected from

the list by using

After an item selected, apply it by pressing

4. Back

Note

• Menu adjustments and settings (except Lamp power

turned off via the ON/STANDBY button. If the power cord is unplugged before this, or the

power goes out, then the data will not be saved.

Display the Setting display menu

Displays the current

adjustments of selected

category.

Item shown with gray

cannot be adjusted for the

current input source.

to open the menu

5. To Finish

Finish via the Status

display menu.

This mark signfy that

there are options.

Press

to display a

To Status display

list of options.

p.32

6. End

The menu disappears

p.54

) are saved when the power is