Toshiba TDP-MT500 Manuel du propriétaire - Page 37

Parcourez en ligne ou téléchargez le pdf Manuel du propriétaire pour {nom_de_la_catégorie} Toshiba TDP-MT500. Toshiba TDP-MT500 42 pages. Home projector
Également pour Toshiba TDP-MT500 : Manuel du propriétaire (40 pages)

Toshiba TDP-MT500 Manuel du propriétaire
Projected images are irregular.
Phenomenon
Projected images are distorted.
Projected images are
dark.
Projected images are
blurred.
White dots are seen in
projected images.
Black dots are seen in
the projected images.
A rainbow-color brume pattern
is seen on projected images.
Fine streak pattern is seen
on projected images.
Projected images are
disturbed.
Tint of projected images
is irregular.
Others
Phenomenon
A hot air comes out of
the exhaust vent.
Menu setting is dis-
abled.
Abnormal sounds oc-
cur.
If the following phenomenon occurs after the lamp has been replaced, check the following first:
Phenomenon
P o w e r c a n n o t b e
turned on.
Check/Countermeasure
Adjust the projector and the screen so that they may become perpendicular to each other. (See Page 11.)
Adjust BRIGHT and CONTRAST in the picture quality menu. (See Page 28.)
Replace the lamp to a new one. (See Page 32 and 33.)
Adjust the focus. (See Page 18 and 22.)
Check if the lens cap is not put on.
Clean the lens.
Adjust "FINE" and "DIVIDING RATIO" in the signal setting menu. (See Page 30.)
Adjust BRIGHT and CONTRAST in the picture quality menu. (See Page 28.)
Adjust the projector and the screen so that they may become perpendicular to each other.
(See Page 11.)
This phenomenon is proper to DLP projector and is not a failure. (A very small number of
pixels may be constantly lighting on or off, but this is not a failure. Pixels of more than
99.99% are effective ones.)
This pattern is a color breaking noise that occurs in DLP system in principle. This is not a
failure.
This phenomenon occurs due to the interference with the screen surface, and is not a
failure. Try to replace the screen or defocus the lens a little.
Securely plug the cable connecting the external equipment to the bottom.
Keep the projector away from equipment generating interfering radiowaves.
Check if the cable connecting the external equipment is broken.
Check/Countermeasure
• This air comes out after cooling the inside of the projector. It may feel hot, but is not a
failure.
• Affected by noises, the microcomputer in the projector may be malfunctioning.
–>Turn off POWER once, and after 2 minutes turn it on again.
• If POWER can not be turned off, turn off the main power switch and leave the projector as
it is for more than 10 minutes. Then, turn on POWER again.
• On rare occasions, a metallic clank occurs because the color wheel is rotating at a high
speed. But, this is not a failure.
Check/Countermeasure
Securely fit the rear lamp cover. (See Page 32 and 33.)
Reset the lamp-used-hours. (See Page 33.)
TROUBLESHOOTING
37