Toshiba TLP-MT3 Manuel du propriétaire - Page 33

Parcourez en ligne ou téléchargez le pdf Manuel du propriétaire pour {nom_de_la_catégorie} Toshiba TLP-MT3. Toshiba TLP-MT3 43 pages. Lcd projector
Également pour Toshiba TLP-MT3 : Spécifications (2 pages)

Imprimer la page

Maintenance

Lamp replacement

The lamp will eventually begin to project dark

or dull pictures and finally will not light up.

(Lamp's life length depends on the use

condition.) In such a case, replace the lamp

with new one.

CAUTION

• If you use the projector mounted on the

ceiling, ask the dealer to carry out the

maintenance such as cleaning or

replacement of the lamp.

• When replacing, always use lamp "TLPL8"

(sold separately). For detail, refer to TLPL8

instruction.

• If you have been using the projector, the

lamp will be very hot, and may cause burn

injuries. Wait for the lamp to cool (for longer

than 1 hour) before replacing it.

• If the lamp should break, please handle with

care to avoid injury due to broken pieces

and contact your dealer for repair service.

Unplug the power cord.

Wait until the lamp gets cold

enough.

Take off the lamp cover on the

bottom panel.

Loosen two screws, and pull off the lamp

cover.

Pull out the lamp.

Loosen the two fixing screws, and lift up

the handle to pull out the lamp.

Load a new lamp.

Slide until it hits the bottom and tighten

the two fixed screws.

Attach the lamp cover.

Slide the cover in place and tighten two

screws.

Reset the lamp timer.

Refer to the lamp instructions for

resetting.

Notes

• The projector displays the total working time

at every 1,000 hours (only when plugged in

and turned on; ex. " >1000H ", " >2000H ").

• The lamp should be replaced if the total

working time exceeds about 2,000 hours.

• Attach the lamp cover firmly after replacing

the lamp. If it is not set correctly, the power

will not turn on.

• Use a new lamp when replacing it.

• The lamp is made of glass and is very fragile.

Do not touch the lamp with your bare hands

and do not jolt or damage it. Do not use an

exhausted lamp.