Toshiba TLP-S10 Manuel d'entretien - Page 8

Parcourez en ligne ou téléchargez le pdf Manuel d'entretien pour {nom_de_la_catégorie} Toshiba TLP-S10. Toshiba TLP-S10 33 pages. 1,200 ansi-lumens 2.1 kg eco mode
Également pour Toshiba TLP-S10 : Manuel du propriétaire (22 pages), Manuel du propriétaire (22 pages), Spécifications (2 pages)

Imprimer la page

2. Setting of keystone correction

(Perform the adjustment when main

PC board is replaced)

This operation initializes the data of the tilt sensor for

keystone correction.

Tilt sensor's performance abilities vary with the

sensors, and the sensor output data is affected by

change of ambient air temperature. For the measure

above, firstly the micro computer memorizes output

data when the projector is set on level and ±30 degree

surface as general data. Then the software detects

tilt of the projector with the general data as a base.

Moreover, the micro computer memorizes the level

position data when the sensor is warmed up with the

heat run. The data is used to correct the temperature

drift correction.

2-1. Adjustment of low temperature

(1) Select [KEYSTONE] from starting menu.

Check 0, +30, -30 and click [Start] button.

(2) Set the projector on a level surface.

Click [OK] to start.

(3) Keep projector on 30 degree and click [OK].

(4) Keep projector -30 degree and click [OK].

(5) After the adjustment was completed, the following

message appears. Click [OK].

(Note)

When the following error message appears (the

projector is not tilted accurately +/- 30 degree,

etc), check the connection or set the projector to

specified angle. And then restart the adjustment

from beginning.