AEO WP40SP10 Manuel de l'utilisateur - Page 2

Parcourez en ligne ou téléchargez le pdf Manuel de l'utilisateur pour {nom_de_la_catégorie} AEO WP40SP10. AEO WP40SP10 2 pages. 10w solar panel & dc water pump kit

Imprimer la page

fountain effect above the surface of the water. Use a taller base such as bricks or marble slabs if the cylinder is not

high enough.

Connect one of the fountain heads on top of cylinder tubes for different water patterns.

Place the water pump under the water (fish tank, small pond, etc.), but on top of a base such as a brick or marble

slab to prevent dirt, mud, or sand from getting into the filter. For deep water, the AEO Floating Pad is

recommended and can be found on Amazon.com by searching for "AEO Floating Pad".

2. [Place the Solar Panel] on the garden lawn or soft ground by jabbing the spike into the ground. Adjust the panel to

face it towards the direction of the sun where the sunlight is strongest during the day. Keep the Solar Panel clear of

shade and dirt.

3. [Connect the Water Pump to Solar Panel] by connecting the plugs on the power cable connected to the Solar Panel

(1) and power cable connected to the Water Pump (2) must match in polarity (+ -). Connect the two plugs by

matching the flat sides. See Section 2: CAUTIONS.

Section 4: CLEANING AND MAINTENANCE

Periodically clean the water pump to prevent blockage.

! Caution ! Handle with care to prevent the impeller from falling out and breaking while detaching the unit. Disconnect

Water Pump from Power before cleaning.

1) Pull the filter housing apart from the pump while squeezing the sides.

2) Press on the bottom board while sliding it in the direction of the arrow.

3) Turn the impeller cover counter-clockwise and then carefully pull it out. Impeller maybe attached to the cover or

stay inside the pump. Be aware of the white washers may fall out.

4) Separate the impeller from the water pump or detach it from the impeller cover.

5) Wash every part including the inside of motor chamber and clean out the debris.

6) Assemble the pump in reverse sequence then put water pump back under water, connect power to start running

7) Keep the surface of the solar module clean and wipe it with a soft and moist cloth when necessary.

Section 5: TROUBLE-SHOOTING

*Pump stopped running?

Check power source: make sure the Solar Panel is fully exposed to sunlight and is not covered in shade or dirt.

Check for blockage: clean the pump as described in Section 4: CLEANING AND MAINTENANCE.

Check the water: make sure the water pump is fully submerged in water.

*Pump is running, but there's no water going through?

1) Check for blockage: clean the nozzle tubes, water pump outlet, and filter to remove any debris

Section 6: TECHNICAL DATA AND PUMP CURVE

Peak Power of Solar Panel

Solar Panel Nominal Voltage

MaximumPumpHead (Hmax)

MaximumFlowRate (Qmax)

Cable Length

If the product is defective or damaged upon

delivery, please contact our customer service by

[email protected]

or call

909-698-8199

10W

18V

1.7M | 5.6FT

610LpH | 161GpH

5M | 16.4FT

for help. Thank you!