CRU MoveDock USB 3.0 Manuel de démarrage rapide - Page 2

Parcourez en ligne ou téléchargez le pdf Manuel de démarrage rapide pour {nom_de_la_catégorie} CRU MoveDock USB 3.0. CRU MoveDock USB 3.0 2 pages.

1. Installation Steps

1.1 Hard Drive Installation Steps

a. Remove the drive cover from the carrier.

b. Carefully insert the drive into the carrier. Slide the drive toward the back of

the PCA board on the back of the carrier until it clicks into place.

c. Hold the drive in place and turn the drive/carrier assembly over.

d. Fasten the drive into place with the four (4) provided screws. Some drives

may require minor adjustment.

e. Turn the carrier back over and install the drive cover. Secure it with the

two (2) provided screws.

1.2 Operating Your MoveDock

a. Place the MoveDock and carrier on a table.

b. Make sure that the MoveDock is switched off or is not plugged in.

c. Slowly push the carrier into the

MoveDock until it clicks into place.

NOTE: Failure to follow the correct

insertion procedure can cause pins to

be bent inside of the MoveDock and can

lead to its malfunction.

d. Use the provided USB 2.0 data cable or a USB 3.0 data cable to connect the

MoveDock to your computer.

e. Connect the MoveDock to power using the provided power supply.

Flip the power switch on the rear of the MoveDock to turn it on. The green

power LED will light up to indicate that the MoveDock is powered on.

Your MoveDock is now ready to use! If the hard drive is already formatted, it can

be used right away. If the hard drive is brand new, or its format is not compatible

with your computer, the drive will need to be formatted before being used.

2. LED Activity

LED Name

Color

State

Power

Green

Solid

Drive Activity

Amber

Intermittent

Description

Unit is powered on.

Flashes when the drive is being accessed.

CRU Mark

10.25.12

PMS 711

2 cyan

85 magenta

76 yellow