ARIONA POOLS ALBORAN 1200 Manuel d'instruction et d'entretien - Page 7
Parcourez en ligne ou téléchargez le pdf Manuel d'instruction et d'entretien pour {nom_de_la_catégorie} ARIONA POOLS ALBORAN 1200. ARIONA POOLS ALBORAN 1200 12 pages.
Imprimer la page2.2. INSTALLATION OF VALVE MANIFOLDS
Install the valve manifold before loading the filter with the filter aid. The valve
manifold brackets will support the weight of the valves, the pipes and the water
inside them, and will reduce the force that the filter connections will need to
withstand. It is necessary to install these brackets on a sufficiently resistant surface
and adjust their height correctly.
2.3. HYDRAULIC TEST
Test the filters with water by running the system before filling them with filter aid.
This hydraulic test will detect any problems with water tightness that may have
arisen with the filter or the set up.
2.4. FILLING THE FILTER
Remove the upper cap of the filter and the side cover (if applicable).
•
Check the condition of the internal parts before starting to load the filter aid into
•
the filter. The diffuser and collector must be in perfect condition, and the nozzles
must be in their correct place and fully tightened.
Before loading the filter aid into the filter, fill it approximately halfway with water.
•
If it is a model with a side hole, fill it up to the level of the side hole. This will
prevent damage to the nozzles or collector arms while the filter is being loaded
with the filter aid.
Use a filter aid that is recommended according to the technical information
•
supplied in the filter specifications.
The first layer of gravel should cover the collector and reach to about 10cm
•
above it and be spread evenly across the whole surface. Care should be taken
when carrying out this procedure so as not to damage the collector.
Load the following layers of sand following the same procedure,
•
until the maximum recommended height is reached.
Once the height of the side hole has been reached, replace the cap to
•
continue filling the filter.
Carefully clean the neck of the filter, the cap and the cap seal, removing any
•
remaining traces of filter aid. Finally replace the seal and then replace and tighten
the cap.
Once the filter is full and correctly closed, it must be cleaned.
•
INSTRUCTION AND MAINTENANCE MANUAL
7