Crutchfield 120 90-3037P Manuel de démarrage rapide - Page 2
Parcourez en ligne ou téléchargez le pdf Manuel de démarrage rapide pour {nom_de_la_catégorie} Crutchfield 120 90-3037P. Crutchfield 120 90-3037P 3 pages. Installation kit
Imprimer la page
Installation Kit
DIN Receiver Assembly
1.
Press posts on trimplate into holes on kit frame to snap
parts together (Figure 1).
2.
Use a utility knife to cut out shaft supports in trimplate to
create a DIN opening (Figure 2).
3.
Push clips on support tray into slots on rear of kit frame to
secure (Figure 1).
4.
Cut off tabs on both mounting brackets labeled "B" and "C"
that are shown as shaded (Figure 3). The "A" tabs must
remain.
5.
Secure mounting brackets to sides of kit frame with studs
and nuts supplied (Figure 1).
6.
Remove DIN sleeve from receiver and slide into opening in
trimplate. Secure sleeve to trimplate by bending the securing
tabs (Figure 4).
7.
Slide receiver into sleeve/kit assembly.
Tools Required
Cut off
1/4" & 3/8"
"B" & "C" tabs
Sockets
(shaded)
Utility
Knife
Small Flat Blade
Screwdriver
Hacksaw
FIGURE 3
"C"
"A" tabs remain
FIGURE 2
Shaft Supports
FIGURE 1
Left Mounting Bracket
Trimplate
"B"
"A"
FIGURE 4
"B"
Securing Tabs
"A"
Bend tabs after sleeve
is inside assembly.
120 90-3037P
Chevrolet/GMC
Support Tray
Kit Frame
Stud
Right Mounting Bracket
DIN Sleeve
Copyright 2004 Crutchfield Corporation
Nut
®
2