Aeon Labs Aeotec Z-Stick Gen5 Manuel - Page 6

Parcourez en ligne ou téléchargez le pdf Manuel pour {nom_de_la_catégorie} Aeon Labs Aeotec Z-Stick Gen5. Aeon Labs Aeotec Z-Stick Gen5 17 pages. Z-wave usb adapter
Également pour Aeon Labs Aeotec Z-Stick Gen5 : Manuel de démarrage rapide (11 pages)

Imprimer la page
Aeon Labs Aeotec Z-Stick Gen5 Manuel
Adding your Sensor to your Z-Wave network.
With your mounting plates prepared to hold each component of
your sensor, it's time to add it to your Z-Wave network.
1.
Let your Z-Wave primary controller/gateway enter into
adding/inclusion mode.
2.
Take your Sensor near to your primary controller.
3.
Press the Action Button once on your Sensor.
4.
If your Door Window Sensor has been successfully added
to your Z-Wave network, its Status LED will fast blink for 2
seconds and then be solid for 2 seconds when you press the
Action Button again. If the adding was unsuccessful and the
Status LED continues to fast blink for 8 seconds and then
slow blink for 3 seconds, repeat the above steps.
With your Door Window Sensor now working as a part of
your smart home, you'll be able to configure it from your home
control software or phone application. Please refer to your
software's user guide for precise instructions on configuring
Door Window Sensor to your needs.
Attach your sensor to its plates.
With your sensor added to your Z-Wave network, it's now time
to insert each main part of your sensor into the corresponding
sensor plate.
1.
Insert the larger of your two sensor parts into the large
mounting plate ensuring that the dimple on the front is on the
same side as the smaller mounting plate.
2.
lnsert the smaller of your two sensor parts into its mounting
plate.