Aeon Labs Aeotec Manuel de l'utilisateur - Page 9
Parcourez en ligne ou téléchargez le pdf Manuel de l'utilisateur pour {nom_de_la_catégorie} Aeon Labs Aeotec. Aeon Labs Aeotec 11 pages. Home energy meter
Également pour Aeon Labs Aeotec : Manuel de l'utilisateur (7 pages), Manuel (9 pages)
Imprimer la page
17.09.2018
1. Let the garage door move to full close position via sending control commands or pressing manual Switch.
2. Send this parameter (34) with "value=1" to Garage Door Controller through your gateway/controller.
3. Let the garage door move to full open position via sending control commands or pressing manual Switch.
4. Let the garage door move to full close position via sending control commands or pressing manual Switch after the
step 3 has completed.
Calibrating the Garage Door Controller Manually.
You can also calibrate the Garage Door Controller manually using these steps, you do not have to use configuration
settings to put the garage door, and may be more preferable and easier to do so manually.
1. Ensure that the garage door is closed, and the tilt sensor is in an CLOSED position, while the GDC shows a
CLOSED status on your gateway interface.
2. Using the main button located at the very front of the unit (Switch Button), press and hold its button down for 10
seconds, then let go. If successful, the network LED on the back will be blinking rapidly to indicate that it is in
calibration mode.
3. Open the garage door using the Switch Button of the GDC, or through Z-Wave commands. Let it open all the
way.
4. Now close the garage door using the Switch Button on the GDC, or through Z-Wave commands. Let it close all
the way.
5. Calibration is now complete.
Advanced Instructions.
IMPORTANT SAFETY INSTRUCTIONS.
WARNING — TO REDUCE THE RISK OF SEVERE INJURY OR DEATH:
1. READ AND FOLLOW ALL INSTRUCTIONS.
2. NEVER LET CHILDREN OPERATE OR PLAY WITH DOOR CONTROLS. KEEP REMOTE CONTROL AWAY FROM
CHILDREN.
3. ALWAYS KEEP MOVING DOOR IN SIGHT AND AWAY FROM PEOPLE AND OBJECTS UNTIL IT IS COMPLETELY
CLOSED. NO ONE SHOULD CROSS THE PATH OF THE MOVING DOOR.
4. SAVE THESE INSTRUCTIONS.
Removing Your Garage Door Controller from a Z-Wave network.
The following instructions will tell you how to remove your Garage Door Controller from your Z-Wave network via an
Aeotec by Aeon Labs' Z-Stick or Minimote controller. If you are using another Z-Wave controller as your main controller,
please refer to their respective manual on how remove devices from your network.
If you're using an existing gateway (ie. Vera, Smartthings, ISY994i ZW, Fibaro, etc):
You may need to refer to your gateway's method of excluding or unpairing devices if you do not know how to unpair a
Z-Wave device.
1. Put your primary Z-Wave gateway into unpair or exclusion mode, your Z-Wave gateway should confirm that it is
waiting to add a new device
2. Press the Z-Wave Button on the Garage Door Controller. The LED on Garage Door Controller will blink rapidly,
followed by a solid LED for 1-2 second for a successful exclusion.
3. The Network LED on the Garage Door Controller should now be blinking slowly to indicate it is ready to be paired
to a new network.
https://aeotec.freshdesk.com/support/solutions/articles/6000053811-garage-door-controller-gen-5-user-guide-
Garage Door Controller Gen5 user guide. : Aeotec by Aeon Labs
9/11