Pioneer AVIC-Z720DAB Manuel d'installation - Page 9
Parcourez en ligne ou téléchargez le pdf Manuel d'installation pour {nom_de_la_catégorie} Pioneer AVIC-Z720DAB. Pioneer AVIC-Z720DAB 17 pages. Navigation av system
Également pour Pioneer AVIC-Z720DAB : Manuel de démarrage rapide (16 pages), Instructions pour la mise à jour du micrologiciel du système (5 pages)
Imprimer la page
• GPS aerial and its lead
In addition, you should lay or route each
aerial lead as far as possible from other
aerial leads. Do not bind, lay or route them
together, or cross them. Electromagnetic
noise will increase the potential for errors
in the vehicle's location display.
Before installing
• Consult with your nearest dealer if
installation requires drilling holes or
other modifications of the vehicle.
• Before making a final installation of this
product, temporarily connect the wiring
to confirm that the connections are
correct and the system works properly.
For AVIC-Z920DAB users
Do not install this product in a position
where the opening of the LCD panel is
obstructed by any obstacles, such as the
gearstick. Before installing this product, be
sure to leave sufficient space so that the
LCD panel does not obstruct the gearstick
when it is fully opened. This may cause
interference with the gearstick, or a
malfunction of the mechanism of this
product.
Installation notes
• Do not install this product in places
subject to high temperatures or
humidity, such as:
– Places close to a heater, vent or air
conditioner.
– Places exposed to direct sunlight, such
as on top of the dashboard.
– Places that may be exposed to rain,
such as close to the door or on the
vehicle's floor.
• Install this product in an area strong
enough to bear its weight. Choose a
position where this product can be firmly
installed, and install it securely. If this
product is not securely installed, the
current location of the vehicle cannot be
displayed correctly.
• Install this product horizontally on a
surface within 0 to 30 degrees tolerance
(within 5 degrees to the left or right).
Improper installation of the unit with the
surface tilted more than these tolerances
increases the potential for errors in the
vehicle's location display, and might
otherwise cause reduced display
performance.
• When installing, to ensure proper heat
dispersal when using this unit, make sure
you leave ample space behind the rear
panel and wrap any loose cables so they
are not blocking the vents.
5 cm
Leave ample
space
5 cm
• The cords must not cover the area shown
in the figure below. This is necessary to
allow the amps and navigation
mechanism to dissipate heat.
Do not cover this area.
• The semiconductor laser will be damaged
if it overheats, so don't install this product
anywhere hot- for instance, near a heater
outlet.
Installation using the screw
holes on the side of this
product
1
Fastening this product to the factory
radio-mounting bracket.
Position this product so that its screw
holes are aligned with the screw holes
of the bracket, and tighten the screws at
three locations on each side.
Use either the truss head screws or flush
surface screws, depending on the shape
of the bracket's screw holes.
Factory radio-mounting bracket
If the pawl interferes with
installation, you may bend it down
out of the way.
Dashboard or console
Truss head screw or flush surface
screw
Be sure to use the screws supplied
with this product.
Installing the GPS
aerial
CAUTION
Do not cut the GPS aerial lead to shorten it
or use an extension to make it longer.
Altering the aerial cable could result in a
short circuit or malfunction and
permanent damage to this product.
Installation notes
• The aerial should be installed on a level
surface where radio waves will be
blocked as little as possible. Radio waves
cannot be received by the aerial if
reception from the satellite is blocked.
En
9