Pioneer AVX-7000 Manuel d'entretien - Page 28

Parcourez en ligne ou téléchargez le pdf Manuel d'entretien pour {nom_de_la_catégorie} Pioneer AVX-7000. Pioneer AVX-7000 32 pages. 7 inch wide av system display
Également pour Pioneer AVX-7000 : Manuel (24 pages), Manuel d'entretien (16 pages)

Imprimer la page

AVX-7000

- Discharging operations

1. When the OPEN key or the ACC is turned "ON"(or

detach grille installing ), (2 sec. after) the position

motor will be activated under the high speed mode.

2. When the longitudinal position sensing switch (PUSH

SW)/(LIFT SW) turns H - L, the position motor will be

stopped and, at the same time, the angle motor will

be activated at high speed.

3. When the electric potential of the angle encoder

reaches 90° (Reference 0° potential + 3.047V), the

angle motor will be stopped. (Braking mode)

However, if the preceding angle is being memorized,

the angle motor will keep running until the

memorized angle can be obtained.

- Storage operation

1. When the CLOSE key is operated (or 6 sec. after

turning "OFF" the ACC while the automatic open-

close setting is being turned "ON"), the angle motor

will be activated at low speed.

2. At 750ms after the angle 0° potential has been

reached, the angle motor will be stopped and the

position motor will be activated at high speed. The

system will go into stopping movement at the point

where the PULL SW is turned "ON" by detection or

when the error time is over.

90° potential or

the memorized

position