Pioneer DEH P4800MP Manuel d'utilisation - Page 28
Parcourez en ligne ou téléchargez le pdf Manuel d'utilisation pour {nom_de_la_catégorie} Pioneer DEH P4800MP. Pioneer DEH P4800MP 36 pages. Multi-cd control high power cd/mp3/wma player with rds tuner
MAN-DEH-P4800MP-GB.fm Page 28 Thursday, September 29, 2005 11:55 AM
Audio Adjustments
Adjusting source levels
SLA (source level adjustment) lets you adjust the volume level of each source to
prevent radical changes in volume when switching between sources.
• Settings are based on the FM tuner volume level, which remains unchanged.
1. Compare the FM tuner volume level with the level of the source you wish to
adjust.
2. Press AUDIO to select SLA.
Press AUDIO until SLA appears in the display.
3. Press 8 or 2 to adjust the source volume.
Each press of 8 or 2 increases or decreases the source volume.
SLA : +4 – SLA : –4 is displayed as the source volume is increased or decreased.
Notes
• Since the FM tuner volume is the control, it is not possible to apply source level adjustments
to the FM tuner.
• The MW/LW tuner volume level can also be adjusted with source level adjustments.
• The built-in CD player and the multi-CD player are set to the same source level adjustment
volume automatically.
• External unit 1 and external unit 2 are set to the same source level adjustment volume
automatically.
Initial Settings
Adjusting initial settings
Using the initial settings, you can customize various system settings to achieve optimal
performance from this unit.
Function display
Shows the function status.
1. Press SOURCE and hold until the
unit turns off.
2. Press SOURCE and hold again until
function name appears in the display.
3. Press FUNCTION to select one of the initial settings.
Press FUNCTION repeatedly to switch between the following settings:
FM (FM tuning step) – A-PI (auto PI seek) – AUX1 (auxiliary input1) – AUX2 (auxiliary
input2) – R-SP (rear output and subwoofer controller) – SAVE (power save)
• To cancel initial settings, press BAND.
• You can also cancel initial settings by holding down SOURCE until the unit turns off.
Setting the FM tuning step
Normally the FM tuning step employed by seek tuning is 50 kHz. When AF or TA is on,
the tuning step automatically changes to 100 kHz. It may be preferable to set the
tuning step to 50 kHz when AF is on.
1. Press FUNCTION to select FM.
Press FUNCTION repeatedly until FM appears in the display.
2. Press 4 or 6 to select the FM tuning step.
Pressing 4 or 6 will switch the FM tuning step between 50 kHz and 100 kHz while AF
or TA is on. The selected FM tuning step will appear in the display.
Note
• The tuning step remains at 50 kHz during manual tuning.
28