Pioneer DEH-3050UB Manuel d'installation
Parcourez en ligne ou téléchargez le pdf Manuel d'installation pour {nom_de_la_catégorie} Pioneer DEH-3050UB. Pioneer DEH-3050UB 7 pages.
Imprimer la page
DEH-3050UB
Printed in China
<YRD5190-A/S> ES
<KMINX> <07I00000>
Installation
English
3. Install the unit as illustrated.
Note
• Check all connections and systems before final
Mounting sleeve
Dashboard
installation.
• Do not use unauthorized parts. The use of
182
1 1 1 82
unauthorized parts may cause malfunctions.
• Consult with your dealer if installation requires
Rubber bush
53
53
drilling of holes or other modifications of the
vehicle.
• Do not install this unit where:
Screw
— it may interfere with operation of the vehicle.
— it may cause injury to a passenger as a result
of a sudden stop.
• The semiconductor laser will be damaged if it
overheats. Install this unit away from hot places
such as near the heater outlet.
Removing the Unit
• Optimum performance is obtained when the unit is
1. Extend top and bottom of the trim
installed at an angle of less than 60°.
ring outwards to remove the trim
ring. When reattaching the trim ring,
60°
push the trim ring onto the unit until
it clicks. (If the trim ring is attached
upside down, the trim ring will not
• When installing, to ensure proper heat dispersal
fit properly.)
when using this unit, make sure you leave ample
• It becomes easy to remove the trim ring if the
space behind the rear panel and wrap any loose
front panel is released.
cables so they are not blocking the vents.
DIN Front/Rear-mount
Trim ring
This unit can be properly installed either from
"Front" (conventional DIN Front-mount) or
"Rear" (DIN Rear-mount installation, utilizing
threaded screw holes at the sides of unit
chassis). For details, refer to the following
installation methods.
2. Insert the supplied extraction keys
DIN Front-mount
into both sides of the unit until
they click into place.
Installation with the rubber bush
1. Insert the mounting sleeve into the
dashboard.
• When installing in a shallow space, use a
supplied mounting sleeve. If there is enough
space behind the unit, use factory supplied
mounting sleeve.
2. Secure the mounting sleeve by
using a screwdriver to bend the
metal tabs (90°) into place.
3. Pull the unit out of the dashboard.
Installation
English
DIN Rear-mount
1. Extend top and bottom of the trim
ring outwards to remove the trim
ring. When reattaching the trim ring,
push the trim ring onto the unit until
it clicks. (If the trim ring is attached
upside down, the trim ring will not
fit properly.)
• It becomes easy to remove the trim ring if the
front panel is released.
Trim ring
2. Determine the appropriate position
where the holes on the bracket and
the side of the unit match.
3. Tighten two screws on each side.
• Use either truss screws (5 mm × 8 mm)
or flush surface screws (5 mm × 9 mm),
depending on the shape of screw holes in the
bracket.
Screw
Dashboard or Console
Factory radio mounting bracket