Pioneer DEH-9 Manuel d'installation - Page 2

Parcourez en ligne ou téléchargez le pdf Manuel d'installation pour {nom_de_la_catégorie} Pioneer DEH-9. Pioneer DEH-9 4 pages. Pioneer deh-1900mp: user guide
Également pour Pioneer DEH-9 : Manuel d'utilisation (39 pages)

Imprimer la page

1. Connecting the Units

Connecting the Units

This Product

Rear output

Fuse (10 A)

Antenna jack

Blue/white

Connect to system control terminal of

the power amp or auto-antenna relay control

terminal (max. 300 mA 12 V DC).

Yellow

Connect to the constant 12 V supply terminal.

Red

Connect to terminal controlled by ignition switch (12 V DC).

Black (chassis ground)

Connect to a clean, paint-free

With a 2 speaker system, do not connect

metal location.

anything to the speaker leads that are not

connected to speakers.

Perform these connections when using

the optional amplifier.

Connect with RCA cables

(sold separately)

System remote control

White

Gray

Front speaker

≠

White/black

Gray/black

Left

Right

Green

Violet

Rear speaker

≠

Green/black

Violet/black

Rear speaker

≠

ENGLISH

Installation

Note:

•

Check all connections and systems before final

installation.

•

Do not use unauthorized parts. The use of

unauthorized parts may cause malfunctions.

•

Consult with your dealer if installation requires

drilling of holes or other modifications of the

vehicle.

•

Do not install this unit where:

Power amp

— it may interfere with operation of the vehicle.

(sold separately)

— it may cause injury to a passenger as a result

of a sudden stop.

•

The semiconductor laser will be damaged if it

overheats. Install this unit away from hot places

such as near the heater outlet.

•

Optimum performance is obtained when the unit

is installed at an angle of less than 60°.

60°

DIN Front/Rear-mount

This unit can be properly installed either from

"Front" (conventional DIN Front-mount) or

"Rear" (DIN Rear-mount installation, utilizing

threaded screw holes at the sides of unit chassis).

For details, refer to the following installation

methods.

DIN Front-mount

DIN Rear-mount

1. Extend top and bottom of the trim ring outwards

Installation with the rubber bush

to remove the trim ring. (When reattaching the

trim ring, point the side with a groove downwards

Mounting sleeve

Dashboard

and attach it.)

•

It becomes easy to remove the trim ring if the

182

front panel is released.

Rubber bush

Screw

1. Insert the mounting sleeve into the dashboard.

•

When installing in a shallow space, use a sup-

2. Determine the appropriate position where the

plied mounting sleeve. If there is enough

holes on the bracket and the side of the unit

space behind the unit, use factory supplied

match.

mounting sleeve.

2. Secure the mounting sleeve by using a screwdriv-

er to bend the metal tabs (90°) into place.

3. Install the unit as illustrated.

Removing the Unit

1. Extend top and bottom of the trim ring outwards

to remove the trim ring. (When reattaching the

trim ring, point the side with a groove downwards

3. Tighten two screws on each side.

and attach it.)

Use either truss screws (5 mm × 8 mm) or

•

flush surface screws (5 mm × 9 mm), depend-

•

It becomes easy to remove the trim ring if the

front panel is released.

ing on the shape of screw holes in the

bracket.

Trim ring

2. Insert the supplied extraction keys into both sides

of the unit until they click into place.

3. Pull the unit out of the dashboard.

Factory radio mounting bracket

ENGLISH

Fastening the front panel

If you do not plan to detach the front panel, the

front panel can be fastened with supplied screw.

Trim ring

Screw

Dashboard or Console