Pioneer XV-DV353 Manuel d'utilisation - Page 33
Parcourez en ligne ou téléchargez le pdf Manuel d'utilisation pour {nom_de_la_catégorie} Pioneer XV-DV353. Pioneer XV-DV353 50 pages. Dvd/cd receiver; speaker system
Également pour Pioneer XV-DV353 : Manuel d'utilisation (48 pages)
Imprimer la page
Other connections
Important
• With an SR+ cable connected, the remote
must now be pointed towards your plasma
display rather than the remote sensor of
this unit in order to control this system.
•
Use a 3-ringed miniplug SR+ cable to
connect the CONTROL IN jack of this unit
through a media receiver to the CONTROL
OUT jack of your plasma display.
Before you can use the extra SR+ features, you
need to make a few settings in the unit. See
SR+ Setup for Pioneer plasma displays below
for detailed instructions.
SR+ Setup for Pioneer plasma
displays
Make the following settings if you have
connected a Pioneer plasma display to this
unit using an SR+ cable. Note that the number
of video inputs available will depend on the
plasma display you've connected.
1
Press SHIFT+SR+ on the remote.
2
Use the
to select SETUP, then
press ENTER.
3
Use
to select the setting you want.
• VOL.C OFF – This unit does not control the
volume of the plasma display.
• VOL.C ON – When this unit is switched to
one of the inputs that use the plasma
display (DVD, or another one of functions
below), the volume on the plasma display is
muted so only sound from this system is
heard.
Note
1 You won't be able to use the remote sensor of this unit with the CONTROL IN jack of this unit connected to the CONTROL
OUT jack of your plasma display. You can use the remote sensor of the plasma display (even in standby) as long as the power
isn't switched off.
2 The PDP5 input may be called 'PC Input' (or similar) on your plasma display.
4
Assign any input source connected to the
plasma display to the corresponding input
number.
Use
(LINE) or USB), then
number.
This matches this unit's input source with a
numbered video input on the plasma display.
For example, select the LN PDP3 setting if the
video output of your line component is
1
connected to video input 3 on the plasma
display. TVTN switches the plasma display to
its built-in tuner and NONE leaves the plasma
display input as is (no switching takes place).
5
When you're finished, press ENTER .
Switching on the SR+ mode
1
Press SHIFT+SR+ on the remote.
2
Use
ENTER.
To switch SR+ control off, select SR+ OFF.
• If you disconnect the SR+ cable or switch
the plasma display off while SR+ is on, the
SR+ ON setting remains.
• The SR+ setting is maintained even after
switching this system into standby then
back on. Automatic muting will be effective
when this system is switched on.
to select the source (DVD, LN
to select the input
to select SR+ ON then press
09
2
33
En