Pioneer AVH-X3800DAB Manuel d'installation - Page 3
Parcourez en ligne ou téléchargez le pdf Manuel d'installation pour {nom_de_la_catégorie} Pioneer AVH-X3800DAB. Pioneer AVH-X3800DAB 48 pages. Dvd rds av receiver
Également pour Pioneer AVH-X3800DAB : Manuel de démarrage rapide (8 pages), Instructions pour la mise à jour du micrologiciel (3 pages)
Imprimer la page
Connection
This product
1
3
2
4
c b
a
1 Pioneer navigation system
Please contact your dealer to inquire about the connectable
navigation unit.
2 RGB cable(supplied with Navigation system)
3 Microphone 4 m
4 This product
5 Wired remote input
Hard-wired remote control adapter can be connected (sold
separately).
6 Digital Radio aerial input
(AVH-X5800DAB) (AVH-X3800DAB)
7 Aerial jack
8 Power supply
9 Fuse (10 A)
a Front output (STD)/High range output (NW)
b Rear output (STD)/Middle range output (NW)
c SubWoofer output (STD)/Low range output (NW)
Power cord
2
2*
5
4*
6
7
8
9
8
7
9
g
1.
l
1
1*
3*
3
4
5
6
c
a (5*)
b (6*)
d
e
f
2.
i
h
j
k
1 To power supply
2 Depending on the kind of vehicle, the function of 2* and 4*
may be different. In this case, be sure to connect 1* to 4*
and 3* to 2*.
3 Yellow (2*)
Back-up (or accessory)
4 Yellow (1*)
Connect to the constant 12 V supply terminal.
5 Red (4*)
Accessory (or back-up)
6 Red (3*)
Connect to terminal controlled by ignition switch (12 V DC).
7 Connect leads of the same colour to each other.
8 Orange/white
To lighting switch terminal.
9 Black (earth)
To vehicle (metal) body.
a Blue/white (5*)
The pin position of the ISO connector will differ depending
on the type of vehicle. Connect 5* and 6* when Pin 5 is an
aerial control type. In another type of vehicle, never connect
5* and 6*.
b Blue/white (6*)
Connect to auto-aerial relay control terminal (max. 300 mA
12 V DC).
c Blue/white
Connect to system control terminal of the power amp (max.
300 mA 12 V DC).
d Violet/white
Of the two lead wires connected to the back lamp, connect
the one in which the voltage changes when the gear shift
is in the REVERSE (R) position. This connection enables
the unit to sense whether the car is moving forwardss or
backwardss.
e Yellow/black
If you use an equipment with Mute function, wire this lead
to the Audio Mute lead on that equipment. If not, keep the
Audio Mute lead free of any connections.
f Light green
Used to detect the ON/OFF status of the handbrake. This
lead must be connected to the power supply side of the
handbrake switch.
g Connection method
1 Clamp the lead.
2 Clamp firmly with needle-nosed pliers.
h Power supply side
i Handbrake switch
j Earth side
k Speaker leads
White: Front left + or high range left +
White/black: Front left – or high range left –
3