Pioneer VSX-821-K Manuel d'utilisation - Page 9

Parcourez en ligne ou téléchargez le pdf Manuel d'utilisation pour {nom_de_la_catégorie} Pioneer VSX-821-K. Pioneer VSX-821-K 20 pages. Audio/video multi-channel receiver
Également pour Pioneer VSX-821-K : Spécifications (2 pages), Manuel d'entretien (9 pages)

Imprimer la page

Controls and displays

Number buttons and other component controls

Use the number buttons to directly select a radio frequency

(page 27) or the tracks on a CD, etc. There are other buttons that

can be accessed after

RECEIVER

is pressed. (For example

MIDNIGHT, etc.)

HDD*, DVD*, VCR* – These buttons switch between the hard

disk, DVD and VCR controls for HDD/DVD/VCR recorders.

S.RETRIEVER – Press to restore CD quality sound to

compressed audio sources (page 29).

SB CH – Press to select ON, AUTO or OFF the surround back

channel (page 30).

CH SELECT – Press repeatedly to select a channel, then use

LEV +/– to adjust the level (page 34).

LEV +/– – Use to adjust the channel level.

EQ – Press to switch on/off Acoustic Calibration EQ setting

(page 29).

MIDNIGHT – Switches to Midnight or Loudness listening

(page 31).

SPEAKERS – See Switching the speaker terminal on page 12.

PHASE – Press to switch on/off Phase Control (page 30).

DIMMER – Dims or brightens the display. The brightness can

be controlled in four steps.

 SOURCE

Press to turn on/off other components connected to the receiver

(page 40).

TV CONTROL buttons

These buttons are dedicated to control the TV assigned to the TV

button. Thus if you only have one TV to hook up to this system

assign it to the TV button (page 40).

 – Use to turn on/off the power of the TV.

INPUT – Use to select the TV input signal.

CH +/– – Use to select channels.

VOL +/– – Use to adjust the volume on your TV.

MASTER VOLUME +/–

Use to set the listening volume.

MUTE

Mutes/unmutes the sound.

DISP

Switches the display of this unit. The listening mode, sound

volume, Pre Out setting or input name can be checked by

selecting an input source.

• The Pre Out setting may or may not be displayed, depending

on the input source you have selected.

SHIFT

Press to access the 'boxed' commands (above the buttons) on the

remote. These buttons are marked with an asterisk (*) in this

section.

Loading the batteries

The batteries included with the unit are to check initial operations;

they may not last over a long period. We recommend using

alkaline batteries that have a longer life.

CAUTION

• Incorrect use of batteries may result in such hazards as

leakage and bursting. Observe the following precautions:

Never use new and old batteries together.

Insert the plus and minus sides of the batteries properly

according to the marks in the battery case.

Batteries with the same shape may have different voltages.

Do not use different batteries together.

When disposing of used batteries, please comply with

governmental regulations or environmental public

instruction's rules that apply in your country or area.

Do not use or store batteries in direct sunlight or other

excessively hot place, such as inside a car or near a heater.

This can cause batteries to leak, overheat, explode or catch

fire. It can also reduce the life or performance of batteries.

Operating range of remote control

The remote control may not work properly if:

• There are obstacles between the remote control and the

receiver's remote sensor.

• Direct sunlight or fluorescent light is shining onto the remote

sensor.

• The receiver is located near a device that is emitting infrared

rays.

• The receiver is operated simultaneously with another infrared

remote control unit.

30°

7 m