Pioneer A-333 Manuel d'utilisation - Page 8

Parcourez en ligne ou téléchargez le pdf Manuel d'utilisation pour {nom_de_la_catégorie} Pioneer A-333. Pioneer A-333 13 pages. Stereo amp
Également pour Pioneer A-333 : Manuel d'utilisation (13 pages), Manuel d'entretien (26 pages)

Imprimer la page

PANEL FACILITIES

Use this switch/indicator when you do not wish to pass the

output from input terminal equipment through the various

frequency adjusting circuits (SUBSONIC,

BASS, TREBLE,

BALANCE,

LOUDNESS)

and adaptor terminals (ADPT}.

ON:

The indicator lights: The signals input through the input

terminals

are

reproduced

without

passing

through

the

various frequency adjusting circuits. This results in flat, pure

sound which is a more faithful reproduction of the input

source.

OFF:

The

indicator goes

out: The signal passes

through the

various frequency adjusting circuits.

@ LOUDNESS switch/indicator

Use when listening at low volume levels.

ON:

The indicator lights: Boosts low and high frequencies to give

added punch to playback even at low volume levels.

OFF:

The indicator goes

off: Should

normally

be left in this

position.

NOTE:

This switch does not operate when the DIRECT switch is in the

ON position.

®@ SUBSONIC filter switch/indicator (Model A-443

only)

Use this switch when playing records with coarse grooves.

OFF;

Released position; leave in this position for normal playback,

ON:

Depressed position (the indicator lights). Jn this position,

frequencies of 17 Hz and below are cut, eliminating super-

low-frequency noise caused by coarse record grooves, and

thus helping prevent sound distortion.

NOTE:

This switch does not operate when the DIRECT switch is in the

ON position.

@ BALANCE control

Should normally be left in the center position. Adjust the

balance if the sound is louder from one of the speakers. if

the right side is louder, turn toward the Lileft) position and

if the left side is louder, turn toward the Riright) position.

NOTE: ©

This contro! does not operate when the DIRECT

switch is in the

ON position.

TREBLE tone control

Use to adjust the high-frequency tone. The center position

is the flat (normal) position. When turned to the right, high-

frequency tones are emphasized; when turned to the left,

high-frequency tones are de-emphasized.

NOTE:

This control does not operate when the DIRECT switch is in the

ON position.

At volume levels lower than ''4", the set tone control effect

is obtained.

volume

levels

higher

than

"4",

the

effect

becomes

increasingly weaker.

@ BASS tone control

Use to adjust the low-frequency tone. The center position

is the flat (normal) position. When turned to the right, low-

frequency tones are emphasized; when turned to the left,

low-frequency tones are de-emphasized.

NOTE:

This control does not operate when the DIRECT switch is in the

ON position.

At volume levels lower than ''4"', the set tone control effect

is obtained.

volume

levels

higher

than

"4",

the

effect

becomes

increasingly weaker.

@ PHONES jack

When using headphones,

insert the plug into this jack.

[REAR PANEL]

PHONO terminals.

LINE terminais.

ADAPTOR

OUT terminalis.

ADAPTOR

IN terminals.

DAT/TAPE

1 REC terminals.

DAT/TAPE

1 PLAY terminals.

SPEAKERS B terminals (right channel).

SPEAKERS B terminals (left channel).

Power cord.

Connect this cord to an AC wall socket, or the AC outlet

of an audio timer.

888860680