Ariston ARXXF 109 Manuel d'utilisation - Page 14

Parcourez en ligne ou téléchargez le pdf Manuel d'utilisation pour {nom_de_la_catégorie} Ariston ARXXF 109. Ariston ARXXF 109 24 pages.

Imprimer la page

1. Arızalar Ve Onarımlar

Installation

This instruction manual should be kept in a safe place for

future reference. If the washing machine is sold, transferred

or moved, make sure that the instruction manual remains

with the machine so that the new owner is able to familiari-

se himself/herself with its operation and features.

Read these instructions carefully: they contain vital infor-

mation relating to the safe installation and operation of the

appliance.

Unpacking and levelling

Unpacking

1. Remove the washing machine from its packaging.

2. Make sure that the washing machine has not been

damaged during the transportation process. If it has been

damaged, contact the retailer and do not proceed any

further with the installation process.

4. Close off the holes using the plastic plugs provided.

5. Keep all the parts in a safe place: you will need them

again if the washing machine needs to be moved to ano-

ther location.

Packaging materials should not be used as toys for

children.

Levelling

1. Install the washing machine on a flat sturdy floor, without

resting it up against walls, furniture cabinets or anything

else.

3. Remove the 4 protective

screws (used during tran-

sportation) and the rubber

washer with the correspon-

ding spacer, located on the

rear part of the appliance

(see figure).

2. If the floor is not perfectly

level, compensate for any

unevenness by tightening

or loosening the adjusta-

ble front feet (see figure);

the angle of inclination,

measured in relation to the

worktop, must not exceed

2°.

Levelling the machine correctly will provide it with stability,

help to avoid vibrations and excessive noise and prevent it

from shifting while it is operating. If it is placed on carpet or

a rug, adjust the feet in such a way as to allow a sufficient

ventilation space underneath the washing machine.

Connecting the electricity and water

supplies

Connecting the water inlet hose

ted to the hot water tap. Both pipes may be connected

to the cold water tap using the special Y connection with

multiple attachments, supplied with the appliance (see

figure).

Before making the connection, allow the water to run freely

until it is perfectly clear.

Warning: clean the filters regularly by rinsing it under

running water.

3. Make sure that the hose is not folded over or bent.

The water pressure at the tap must fall within the values

indicated in the Technical details table (see next page).

If the inlet hose is not long enough, contact a specialised

shop or an authorised technician.

Never use second-hand hoses.

Use the ones supplied with the machine.

1. Connect the supply pipe

to the water mains using a

gas 3/4 attachment, fitting the

rubber gasket and the filter

supplied with the appliance

and ensuring that they are

fimly tightened to the taps.

The water supply marked

C must be connected to

the cold water tap; the pipe

marked H must be connec-

2. Connect the other end of

the water inlet hose to the

washing machine,

screwing it onto the ap-

pliance's cold water inlet,

situated on the top right-

hand side on the rear of the

appliance

(see figure).