Pioneer ND-G500 - Amplifier Manuel du propriétaire - Page 5
Parcourez en ligne ou téléchargez le pdf Manuel du propriétaire pour {nom_de_la_catégorie} Pioneer ND-G500 - Amplifier. Pioneer ND-G500 - Amplifier 7 pages. 4-channel gateway amplifier
Également pour Pioneer ND-G500 - Amplifier : Manuel du propriétaire (44 pages), Manuel d'entretien (26 pages), Instructions (4 pages)
Illstallatioll
Vehicle mat or chassis
Installing the amplifier
Amplifier
:
'
Hook fastener
:r
l'
Loop f",I<n"
~t
' .....:>
Adhere the hook fastener (provided) to the
bottom of the amplifier and adhere the
loop fastener (provided) to the installation
location.
A
CAUTION
To prevent malfunction and/or injury
• To en3ure proper heat dissipation of the amplifier,
be sure of the following during installation.
-Allow adequate space above the amplifier for
proper ventilation.
-Do not cover the amplifier with a floor mat or
carpet.
• DO NOT allow amplifier to come into contact
with liquids due to, for example, the location
where the amplifier is installed. Electrical shock
could result. Also, amplifier and speaker damage,
smoke, and overheating could result from contact
with liquids.
In
addition, the amplifier surface and
the surface of any attached speakers could
become hot to the touch and minor bums could
result.
• Do not install the amplifier on unstable places
I
such as the spare tire board.
• The best location for installation differs with the
car model and installation location. Secure the
I
amplifier at a sufficiently rigid location.
• Make temporary connections first and check that
the amplifier and the system operate properly.
• After installing the amplifier, confirm that the
spare tire, jack and tools can be easily removed.
Do not cover these areas.
A
CAUTION
• Do not install in:
-Places where it could injure the driver or pas-
sengers if the vehicle stops suddenly.
-Places where it may interfere with the driver,
such as on the floor in front of the driver's
seat.
• Make sure that wires are not caught in the sliding
mechanism of the seats, resulting in a short-
circuit.
• DO NOT allow amplifier to come into contact
with liquids due to, for example, the location
where the amplifier is installed. Electrical shock
could result. Also, amplifier and speaker damage,
smoke, and overheating could result from contact
with liquids.
In
addition, the amplifier surface and
the surface of any attached speakers could
become hot to the touch and minor bums could
result.
• To ensure proper installation, use the supplied
parts in the manner specified. If any parts other
than the supplied ones are used, they may damage
internal parts of the amplifier, or they may
become loose causing the amplifier to shut down.
• Never replace the fuse with one of greater value
or rating than the original fuse. Use of an
improper fuse could result in overheating and
smoke and could cause damage to the product and
injury including bums.
• The cords must not cover up the area shown in the
figure below. This is necessary to allow the
amplifiers to heat dissipate freely.
Notes:
• Direct installation on the carpet is possible if
the hook fastener will adhere to the carpet. Do
not use the loop fastener in this case.
• Thoroughly wipe off the surface before
affixing the hook and loop fastener.