Pioneer SA-5500II Manuel d'utilisation - Page 5
Parcourez en ligne ou téléchargez le pdf Manuel d'utilisation pour {nom_de_la_catégorie} Pioneer SA-5500II. Pioneer SA-5500II 28 pages.
Également pour Pioneer SA-5500II : Manuel d'utilisation (29 pages)
Imprimer la page
CONNECTIONS
SPEAKER
SYSTEMS
Two sets of stereo speaker systems (A and B) can
be connected to the SA-5500II. Normally employ
the SPEAKERS A terminals when connecting only
one set of speaker systems.
NOTE:
If two
sets of speaker systems
are used simultaneously,
the impedance of each speaker system must be 80hms or
greater.
Malfunction
can
be incurred
if a speaker of less
than 8ohms impedance is connected in this case.
As
shown
in Fig. 1, connect
the right
channel
speaker (as viewed
from listening position) to the
R terminals and the left channel speaker to the L
terminals.
Observe
plus
(+: red) and minus
(-:
black)
polarities of SPEAKERS
terminals and the
terminals
on
rear of speaker systems. Be sure to
connect plus to plus and minus to minus.
Speaker Cord Connection
1. As shown
in Fig. 2, strip about
10mm
of the
insulation
from the end of the speaker cord.
If the conductor
is stranded, twist the strands
together to prevent spreading.
2. While
Holding the terminal button depressed,
insert the end of the cord into the terminal hole.
3. Release
the button
and confirm that cord is
firmly clamped in terminal.
SA-55000
RIGHT SPEAKER
LEFT SPEAKER
SYSTEM
SYSTEM
Fig. 1
SPEAKER
CORD
Fig. 2
ee
eee
eee
11 NKKre
TURNTABLE
Connect
the output cord of a turntable equipped
with a moving magnet (MM) type cartridge to the
PHONO
jacks. If the turntable is provided with
a ground lead, connect this lead to the GND termi-
nal on the rear of the SA-55001.
NOTES:
e
In
addition
to
an
MM
type
cartridge,
an
induced
magnet
(IM) type cartridge can be employed.
In the
case
of a moving
coil (MC)
type cartridge, a special
boosting
transformer
or
head
amplifier
becomes
required.
e
Select
turntable
installation
site carefully.
If it is too
close to the speakers or subject to vibration,
feedback
howling can occur, preventing use at high volumes.
TUNER
Connect' the output of an AM/FM
stereo tuner to
the TUNER jacks.
AUX JACKS
Employ
for connecting
auxiliary
source
compo-
nent (see page 9).
TURNTABLE
TURNTABLE
OUTPUT CORD
PHONO
INPUT
JACKS
INPUT
—
PHONO
TUNER
A
SA-550011
GROUND
LEAD
Fig. 3
OUTPUT
©
L
R
TUNER
SA-55000
INPUT JACKS
TUNER
OUTPUT JACKS
INPUT
PHONO
TUNER
AUX
CONNECTING
CORDS
.
Fig. 4
5