Pioneer SP-X707 Manuel d'utilisation
Parcourez en ligne ou téléchargez le pdf Manuel d'utilisation pour {nom_de_la_catégorie} Pioneer SP-X707. Pioneer SP-X707 23 pages. Surround amplifier
Imprimer la pageOperating Instructions
Bedienungsanleitung
_ Mode d'emploi
Istruzioni per luso
SURROUND
AMPLIFIER
UMFELD-VERSTARKER
AMPLIFICATEUR
ENVELOPPANT
AMPLIFICATORE
DI CIRCONDAMENTO
SP-X707
Thank you for buying this Pioneer product.
Please read through these operating instructions so you will
know how to operate your model! properly. After you have
finished reading the instructions,
put them away in a safe
place for future reference.
In some countries or regions, the shape of the power plug and
power outlet may sometimes differ from that shown in the ex-
planatory drawaings. However, the method of connecting and
operating the unit is the same.
WARNING:
To prevent FIRE OR SHOCK HAZARD,
DO NOT EXPOSE THIS APPLIANCE TO RAIN OR MOISTURE.
IMPORTANT
NOTICE
{For U.S. and Canadian models]
The serial number for this equipment is located on the rear
panel. Please write this serial number on your enclosed war-
ranty card and keep in a secure area. This is for your security.
[For Canadian model]
CAUTION:
to prevent ELECTRIC SHOCK DO NOT
USE THIS (POLARIZED) PLUG WITH AN EXTENSION CORD,
RECEPTACLE OR OTHER OUTLET UNLESS THE BLADES CAN
BE FULLY INSERTED TO PREVENT BLADE EXPOSURE.
ATTENTION:
pour prevenin LES CHOCS ELEC-
TRIQUES NE PAS UTILISER CETTE FICHE POLARISEE AVEC
UN PROLONGATEUR UNE PRISE DE COURANT OU UNE
AUTRE SORTIE DE COURANT, SAUF SI LES LAMES PEUVENT
ETRE INSEREES A FOND SANS EN LAISSER AUCUNE PARTIE
A DECOUVERT.
LINE VOLTAGE
SELECTOR
SWITCHES
Only multi voltage models are provided with these switches,
U.S., Canadian, U.K., Australia and Europe models are not
provided with these switches.
You will find the line voltage selector switches on the rear
panel. Before your model is shipped from the factory, the
switch is set to the power requirements of the destination;
nevertheless, you should check that it is set properly be-
fore plugging the power cord into the AC wall socket. If the
voltage requirements differ, adjust the selector switches as
follows. Before adjusting, disconnect the power cord.
1. Use a medium
size screwdriver.
=~
2. Changing the position of switch A
Insert the screwdriver into the groove on the voltage
selector and adjust so that the tip of the arrow points
to the voltage value of your area.
Medium size
screwdriver
3. Change the position of Switch B
Change the VOLTAGE
SELECTOR
position.
VOLTAGE
SELECTOR
Switch B
[—)
—
<=
=<
=
110-120V
220-240V
NOTE:
Both switches A and B must be in the samme switch ser ting.
PIONEER: