Pioneer VSA-1000 Manuel d'utilisation
Parcourez en ligne ou téléchargez le pdf Manuel d'utilisation pour {nom_de_la_catégorie} Pioneer VSA-1000. Pioneer VSA-1000 35 pages. Av digital surround amplifier
Également pour Pioneer VSA-1000 : Manuel d'utilisation (35 pages)
Imprimer la page
Operating
Instructions
AV DIGITAL SURROUND AMPLIFIER
VSA-1000
NTSC
Thank you for buying this Pioneer product.
Oo
Please read through these operating instructions so you will know how
to operate your model properly. After you have finished reading the
instructions, put them away in a safe place for future reference,
In some countries or regions, the shape of the power plug and power
outlet may sometimes
differ from that shown
in the explanatory
drawings. However, the method of connecting and operating the unit
is the same.
WARNING: To PREVENT FIRE OR SHOCK HAZARD, DO NOT
EXPOSE THIS APPLIANCE TO RAIN OR MOISTURE.
IMPORTANT NOTICE
(For U.S. and Canadian models)
The serial number for this equipment is located on the rear panel.
Please write this serial number on your enclosed warranty card and
keep it in a secure area. This is for your security.
[For Canadian model]
CAUTION: To PREVENT ELECTRIC SHOCK DO NOT USE THIS
(POLARIZED) PLUG WITH AN EXTENSION CORD, RECEPTACLE OR
OTHER OUTLET UNLESS THE BLADES CAN BE FULLY INSERTED TO
PREVENT BLADE EXPOSURE.
{
ATTENTION: Pour PREVENIR LES CHOCS ELECTRIQUES NE
~ PAS UTILISER CETTE FICHE POLARISEE AVEC UN PROLONGATEUR
UNE PRISE DE COURANT OU UNE AUTRE SORTIE DE COURANT,:
SAUF SI LES LAMES PEUVENT ETRE INSEREES A FOND SANS EN
LAISSER AUCUNE PARTIE A DECOUVERT,
FEATURES
BEFORE USING THE UNIT
SURROUND EFFECT.....
FRONT PANEL FACILITIES
REAR PANEL FACILITIES.
CONNECTIONS
OPERATIONS...
CONTE
LINE VOLTAGE SELECTOR SWITCHES
Only multi voltage models are provided with these switches, U.S.,
Canadian, U.K., Australian and Europe models are not provided with
them.
Mains voltages in Saudi Arabia are 127 V and 220 V only. Never use
this model set to 110 V in Saudi Arabia.
You will find the line voltage selector switches on the rear panel. Before
your model is shipped from the factory, the switches are set to the
power requirements of the destination. Nevertheless, you should check
that they are set properly before plugging the power cord into the wall
outlet. If the voltage requirements differ, adjust the selector switches
as follows. Before adjusting, disconnect the power cord.
1. Provide yourself with a medium size screwdriver.
2. Changing the position of switch A, B.
Insert the screwdriver into the slot on the voltage selector and adjust
so that the tip of the slot points to the voltage value of your area.
Changing the position of switch A, B.
Set it to the power voltage of your area.
NOTE:
Both switches A and B must be in the same voltage.
TWO VOLTAGE SELECTORS,
Switch A
Were
Switch B
SE
TNE
[tea ha
220v
\ asa
220
nev wov-rrv
NTS
REMOTE CONTROL OPERATION ..
USE OF LEARNING FUNCTIONS ...
SUPERIMPOSE
TROUBLE SHOOTING .
BLOCK DIAGRAM
SPECIFICATIONS .
@) PIONEER'
The future of sound and vision.