Pioneer VSX-405 Manuel d'utilisation - Page 25

Parcourez en ligne ou téléchargez le pdf Manuel d'utilisation pour {nom_de_la_catégorie} Pioneer VSX-405. Pioneer VSX-405 29 pages. Audio/video stereo receiver
Également pour Pioneer VSX-405 : Manuel d'utilisation (28 pages), Manuel d'entretien (11 pages), Manuel d'entretien (37 pages)

Imprimer la page

TROUBLESHOOTIN NG

—_

Incorrect operations are often mistaken for trouble and malfunctions. If you think that there is something wrong with this

component,

check the points below. Sometimes the trouble may lie in another component.

Investigate the other

components and electrical appliances being used. If the trouble cannot be rectified even after exercising the checks listed

below, ask your nearest PIONEER authorized service center or your dealer to carry out repair work.

Symptom

Cause

Power

does

not come

even

when

the

POWER

switch is pressed.

@ Power cord is disconnected.

e Instances are rare, but the problem may

be due to the operation of the protector

circuit.

@ Connect eta securely.

e Unplug the power cord of the unit from

the AC wall outlet, then plug it in again.

Control is not possible re-

gardless of what operation

button is pressed.

[pores

@ Static electricity affected the unit when

the air is dry, such as in winter.

Ex Be

anne

No sound is produced, even

when the input selector but-

ton is selected.

@ Connections are incorrect.

@ The MUTING

buiton is pressed.

@ » VOLUME

is turned down.

e Unplug the power cord of the unit from

the AC wall outlet, then plug it in again.

e lf static electricity is pronounced,

It is

recommended

that you operate the unit

using the remote control unit.

® Consult pages 9 — 12 and perform con-

nections correctly.

e Press the MUTING button to cancel the

MUTING

effect.

@ Raise volume.

) 5 Speaker connecting wires are discon-

nected from Spear terminals.

@ Connect wires to terminals securely.

® One or both of the input 'cords are dis-

connected.

) Connect input cords securely.

® TAPE 2 MONITOR Gunton | is in itis ON

position.

@ Press the button again to the OFF posi-

tion,

® The SPEAKERS button is OFF.

No picture is produced, even

when the input selector but-

ton is selected.

e Connections

are incorrect.

@ The VCR and the selected input selector

button are not correct.

e Switch the SPEAKERS button ON.

e Consult pages 9 —- 12 and perform con-

nections correctly.

@ Press the correct button.

High noise level.

® Station has not been tuned in to correct

frequency.

@ Antenna has not cheer connected or hae

become disconnected.

@ Confieet the antenna eecaraly:

FM reception

e Accessory

FM antenna

remains

bun-

dled up or it is not pointing in right

direction.

@ Straighen out the antenna and point in

the direction which

provides optimum

reception.

@ Weak broadéasting station signals.

AM reception

@ AM loop antenna is not pointing in right

direction.

® Weak. 6 eadcasuna station sigaale.

patentee

ate

careers

@ Replace accessory FM antenna with out-

"door FM antenna.

| @ Eract Saitek AM

antenna

of connect

@ Change the direction of AM loop antenna

and find a position where

reception is

improved.

ground wire.

e Noise being picked up from this unit ane

other equipment (especially electrical

appliances using motors or fluorescent

lights).

@ Turn off the appliances generating noise

or remove them from vicinity of the ste-

reo equipment.