Pioneer CDJ800Mk1 Instructions de montage - Page 5
Parcourez en ligne ou téléchargez le pdf Instructions de montage pour {nom_de_la_catégorie} Pioneer CDJ800Mk1. Pioneer CDJ800Mk1 5 pages. Optical pickup fitting
Imprimer la page
Illustration 5: Fitting the new part
10. To fit the new pickup, fit the optical pickup rack next to the gearwheel, then carefully fit the
right hand side of the assembly into position, making sure the plastic tabs are as shown in
Illustration 5. If the pickup has a plastic lens cover fitted, remove it.
11. Fit the metal bar back into the optical pickup and into position on the cd mechanism frame.
Fit the two retaining screws. Check that the pickup moves properly by rotating the
gearwheel.
12. Optional step if mechanism is dirty/old. If you have problems after fitting perform this step.
Apply some PTFE spray lube (available from Maplin) to the bar if you have some and also
to the bearing of the spindle motor, the gearwheels and pickup drivemotor. Clean the lens
with a cotton bud and some Isopropyl Alcohol (also available from Maplin).
13. Plug in the 6 way connector to the motor circuit board, then fit the cd mechanism back into
the CDJ. Make sure the green wire is not tucked under the mechanism.
14. Fit the four fixing screws and reattach the green ground strap with the small screw.
15. Plug the wide flexible ribbon cable into the optical pickup, carefully and without creasing.
Its easier if you move the optical pickup up next to the spindle motor.
16. Refit the cover and test.