Pioneer CDX-M2086X1HWL Manuel d'entretien - Page 38

Parcourez en ligne ou téléchargez le pdf Manuel d'entretien pour {nom_de_la_catégorie} Pioneer CDX-M2086X1HWL. Pioneer CDX-M2086X1HWL 50 pages.

CDX-M2086ZBM

12. To see the amount of dislocation, place the mechanism upside-down.

If the stopper bend has been dislocated in the direction of the first

CD, turn VR802 to the left(Fig. 2).

To lower the stage toward the sixth step by 0.1 mm, reduce the volt-

age of EREF (adjusted in step 8) by 20 mV.

If the stopper bend has been dislocated in the direction of the sixth

CD, turn VR802 to the right(Fig. 4).

To raise the stage toward the first step by 0.1 mm, increase the volt-

age of EREF (adjusted in step 8) by 20 mV.

13. Place the mechanism horizontal. Go back to step 11 to reconfirm the

stage height.

14. When adjustment of the stage height is completed, proceed as fol-

lows:

15. Press the EJECT switch.

16. Once operation of the mechanism has stopped, turn the power OFF.

17. Wait more than one minute after the power is turned off, then turn the power ON and insert a magazine.

18. Check if the mechanism operates correctly with the first and fourth CDs.

19. If the mechanism operates properly, adjustment is completed. If the mechanism operates improperly, make the

adjustment again.

VR802

GND

EREF

mV meter