Pioneer CLD-901 Manuel d'utilisation - Page 17

Parcourez en ligne ou téléchargez le pdf Manuel d'utilisation pour {nom_de_la_catégorie} Pioneer CLD-901. Pioneer CLD-901 40 pages. Compact disc/laservision player
Également pour Pioneer CLD-901 : Manuel d'utilisation (40 pages)

Imprimer la page

[To STOP PLAYBACK |

When one side of a disc is played to the end, playback

automatically stops and the disc stops rotating.

To stop playback part way through a disc, proceed as

follows.

Press the EJECT button on the player, or the

EJECT key (@/4) on the remote control unit.

m When

the

EJECT

button

the

player

pressed, the disc stops rotating, and the disc

table emerges.

m When

the EJECT

key on the remote

control

unit is:

Pressed once

: The disc stops rotating.

Pressed twice : The

disc stops

rotating

and

the disc table emerges.

2. Pull out the disc table

3. Remove the disc

Return the disc to its jacket or case, and store it

vertically.

4. Push in the disc table

not

leave the disc table

in the pulled

out

position.

If a strong force is applied to the disc table while

it is pulled out, the disc table may be damaged.

Also depending on the place of installation, there

is a danger of the player falling over.

Except when

inserting or removing a disc, keep the disc table

pushed into the player.

5. Wait several seconds and then turn off the

power.

TV CHANNEL ADJUSTMENT

(WHEN THE PICTURE IS NOT CLEAR)

Confirm that the channel selector switch on the rear

panel of the player, is set to the same channel as the

channel used for disc playback,

1. Set your TV set to the channel (3 or 4) used for

disc playback.

2. Start disc playback.

3. Adjust the fine tuning of your TV set so that a

clear picture is obtained.

(The method of fine tuning differs from one TV set to

another.

Please refer to the operating instructions for

your TV set.)

WHEN

STRIPES

NOISES

APPEAR

THE

SCREEN,

PLEASE

KEEP

VHF

ANTENNA

CABLE

AWAY FROM

POWER

CORD.

BASIC. OPERATION

| TO WATCH A TV BROADCAST

When a VHF TV antenna has been connected to your

TV via the player's ANTENNA terminal, in accordance

with

the

connection

example

given

in these

in-

structions (page 8), TV broadcasts can be received

normally by proceeding in one of the following two

ways:

m By switching off power to the player

Before switching off power, first perform the steps

in "TO STOP PLAYBACK", and stop disc playback.

m= By making the LVP indicator on the front panel

turn off. (Use the TV/LVP key on the remote

control unit.)

In either case, the signals from the VHF

antenna

are fed to the TV set via the player.

VHF

antenna

Press the TV/LVP key on the

remote

control

unit so as to

make the indicator turn off,

or turn off power.

NOTE:

In an area where the TV broadcast signal is weak, slanting

stripes may appear on the TV screen when the TV/LVP key is

pressed to receive a TV broadcast.

However this does not

indicate a fault, and the stripes can be eliminated by turning

off power to the player.

In such

cases,

or when

you

wish

to watch

TV for long

periods of time, we recommend that you turn off the power

switch of the player.

WHEN

USING A TV SET WITH VIDEO AND

AUDIO INPUT TERMINALS

When

using the video

input terminal

of your TV,

switch to the broadcast using the controls of your TV.

B-

: i

AER

SS RT

ERE

SIT

EET TET