Ariston AW122 Manuel rapide - Page 10

Parcourez en ligne ou téléchargez le pdf Manuel rapide pour {nom_de_la_catégorie} Ariston AW122. Ariston AW122 21 pages. Washer / washer-dryer combo
Également pour Ariston AW122 : Livret d'entretien, d'utilisation et d'installation (20 pages), Livret d'entretien, d'utilisation et d'installation (20 pages), Manuel de réparation (20 pages)

Ariston AW122 Manuel rapide
Making the right choice is important. And it’s easy.
Here I'm in control
Washer knob and Delay
start
Use this knob to select the
wash program.
Turn this knob clockwise only.
To select a program, you should
turn the knob so that the word/
number of the desired program
is in line with the pointer on the
knob.
Now press on/off button L , pilot
lamp M will start flashing.
After 5 seconds, the setting will
be accepted, pilot lamp M will
stop flashing (staying lit) and the
wash cycle will begin.
If you want to interrupt the
program in progress or set a new
one, select one of the Reset
positions and wait 5 seconds .
When the cancellation has
been accepted, pilot lamp will
flash 5 times, and you can then
turn the appliance off.
You can use this knob to delay
the appliance's operation.
Select one of the 4 delay time
positions, press the on/off
button L in and wait 5 sec. The
setting has now been accepted
(pilot lamp M stays lit) and you
can select the program you
desire.
Pilot lamp M has a particular
flashing motion (2 sec. on and
4 sec. off) to indicate that a
delayed start has been set.
During this phase, you can
open the appliance door and
change the washing load,
should you wish to do so.
After the wash cycle has been
set and accepted by the
washer-dryer, turning the knob
will have no effect (except for
when it is on position Reset
(Stop).
The detergent dispenser with
the additional bleach
compartment is here.
(For details see page 15).
10
Instructions for installation and use
Knobs are hidden. Just press
them lightly in the middle to
extract them.
Temperature control knob
It is used to set the wash tem-
perature in the recommended
program table on pg. 11. It also
allows you to reduce the tem-
perature recommended for the
selected program, and even to
set a cold wash cycle.
Spin speed knob
It is used to change/exclude
the spin cycle (by choosing
symbol
) of the selected
program. The maximum speed
for the four types of fabric are:
C o t t o n
max rpm
S y n t h e t i c s 800 rpm
W o o l
600 rpm
S i l k
no
Detergent dispenser
It is divided into 3+1 sections:
1. Detergent for pre-wash;
2. Detergent for the main
cycle wash;
3. Fabric conditioner;
4. Bleach.
4
1
2
3
E
F
D
Program key to consult a
straightforward chart of the
different programmes availa-
ble: pull the grey tab outwards
to open it.
Soaking
Soaking
Soaking
Soaking
Soaking
This function allows you to leave
your washing to soak for one
hour during the wash cycle.
During this time, your washing
is also tumbled.
Extra Rinse
This function adds one rinse
cycle
for
Cotton
and
Permanent Press fabrics.
Use of this function is
recommended for improving
rinsing results when washing
full loads when large quantities
of detergent are used.
Recommended for detergent
contact allergies.
Easy iron
When the Easy Iron Button is
selected for either
Permanent Press or Hand
Washables program the
program will stop at a point
marked on the Program Dial
with a black triangle
.
The Program will stall at this
triangle until the customer
removes the clothes and
resets the program, or the
Easy iron button is depressed,
which at that point the program
G
I
L
H
N
M
C
A
B
will continue and finish the
complete cycle.
Pre-wash
With this button, you can pre-
wash on all programs except
the Wool program. (see page
11).
ON-OFF (Power)
To turn on the washer, press
button L in. To turn off, press
button L again so that it is out.
Turning the appliance off
does not cancel the selected
program.
On-Off lamp -
Door lock (Status)
Lamp M flashes slowly when
the appliance is switched on
and awaiting instructions and
at the end of a cycle, indicating
that the door can be opened. It
flashes quickly when the door
should not be opened. A
steady
light
means
appliance has accepted the
the
selected program.
Door locked lamp
The safety lamp indicates the
washing machine door is
locked to prevent it from
beeing opened accidentally.
You must wait 2 minutes for the
lamp to extinguish, before
opening it.
www.aristonappliances.us
the