Pioneer ]S-2EX Manuel d'utilisation - Page 3

Parcourez en ligne ou téléchargez le pdf Manuel d'utilisation pour {nom_de_la_catégorie} Pioneer ]S-2EX. Pioneer ]S-2EX 26 pages. Pioneer speaker system operating instructions
Également pour Pioneer ]S-2EX : Catalogue (20 pages), Brochure & Specs (16 pages), Manuel d'entretien (10 pages)

Imprimer la page

1. Specifications

50 cm

• Place speakers equal distances from your listening

position for good stereo sound. Use speaker cords of the

same length for each speaker.

50˚ – 60˚

• If you are using a set of speakers for your TV sound,

install the speakers at equal distances either side of the

TV and point them in the same direction as the TV.

• Do not place the speaker where it will be in direct

sunlight, and avoid positioning it near heaters and air

conditioners. This may cause warping and discoloration

of the speaker cabinet and damage the speaker.

• Pioneer assumes no liability whatsoever for damages

resulting from assembly, improper mounting, insuffi-

cient reinforcement, misuse of the product, acts of

nature, etc.

Using the spikes

This speaker system includes spikes that you can use to

isolate the speaker from the floor. Spikes are recommended

when placing the speakers on a thick carpet (for added

stability), or for better sound when placing the speakers on a

hard reverberant surface (such as a concrete or wood floor).

Use the supplied spike bases to avoid scratching the floor or

other surface where the speaker is placed.

Speaker base

20 cm

Spike

Nut

Attach the spikes to the nuts provided.

Attach all four spikes to the threaded metal inserts

at the base of the speaker.

Choose the location for speaker placement then put

the spike bases on the floor.

Place the speaker upright so that the spikes are

resting on the spike bases on the floor.

Make sure the speaker is stable and resting squarely on all

four spikes.

Caution: when using the spikes

• Note that these spikes are sharp metal and can cause

damage to flooring. Make sure to lay down a cloth or

suitable base before setting up.

• The speaker is very heavy (about 28 kg) and can cause

serious damage or injury if you are attempting to adjust

the spikes with the speaker standing or leaning. Make

sure to lay down a cloth and make spike adjustments

with the speaker laying flat. Two people or more during

placement and setup is advised.

Connecting to an amplifier

Before connecting to your amplifier, make sure that the amp is

switched off.

This speaker does not include speaker cables used for

connecting to a stereo. Note the following when selecting

speaker cables.

• Use heavy-gauge speaker cable if possible, and keep the

cables to the minimum necessary length.

• If the length of cable required for left and right speakers

differs, use cables of the same length, matched to the

longer distance.

• Cables have differing characteristics. Keep this in mind

when using any cable.

• Select cables with as little resistance as possible, and

make sure the cables to the speaker terminals and amp

are firm and secure.

CAUTION

These speaker terminals carry HAZARDOUS LIVE

voltage. To prevent the risk of electric shock when

connecting or disconnecting the speaker cables,

disconnect the power cord before touching any

uninsulated parts.

Connecting the cables

Switch off the power to your amplifier.

Connect the speaker cables to the input terminals

(lower) on the back of the speaker. For input terminal

polarity, red is positive (+) and black is negative (–).

Grasp the cap knobs on the lower input terminals and rotate

them to the left (counter-clockwise), insert the speaker cable

wires into the holes in the terminal posts, then tighten the

knobs to secure the short bar as well as the wires.

D3-4-2-2-3_A_En