Pioneer PDP-S50 Manuel d'utilisation - Page 6

Parcourez en ligne ou téléchargez le pdf Manuel d'utilisation pour {nom_de_la_catégorie} Pioneer PDP-S50. Pioneer PDP-S50 15 pages.
Également pour Pioneer PDP-S50 : Manuel d'entretien (7 pages)

Imprimer la page

English

HOW TO ROURE CABLES

Speed clamps are included with the Plasma Display for

tidying your cables and keeping extra cable length out of

the way.

Attach speed clamps at the direction of the running cables.

When the Pioneer stand, sold separately, is not used, use the 3

holes that are marked with arrows in the diagram (

holes for attaching speed clamps.

Using Speed Clamps

Wrap the speed clamp around the bundled

cables and press B into hole A.

To remove a speed clamp, use pliers to

twist it 90° and then pull it out. (This may

result in weakening or damaging the

clamp.)

Speaker Cable

∞ Rear of Display

Speed Clamp

Mounting Hole

IMPORTANT NOTICE – RECORD THE MODEL NUMBER AND SERIAL NUMBERS OF THIS EQUIPMENT BELOW.

MODEL NO.

SERIAL NO.

KEEP THESE NUMBERS FOR FUTURE USE.

If you want to dispose this product, do not mix it with general household waste. There is a separate collection system for used

electronic products in accordance with legislation that requires proper treatment, recovery and recycling.

Private households in the 25 member states of the EU, in Switzerland and Norway may return their used electronic products free of charge to

designated collection facilities or to a retailer (if you purchase a similar new one).

For countries not mentioned above, please contact your local authorities for the correct method of disposal.

By doing so you will ensure that your disposed product undergoes the necessary treatment, recovery and recycling and thus prevent potential

negative effects on the environment and human health.

) as the

Speed Clamp

Mounting Hole

THE NUMBERS ARE ON THE REAR.

CABINET MAINTENANCE

÷ Use a polishing cloth or dry cloth to wipe off dust and

dirt.

÷ When the cabinet is very dirty, wipe with a soft cloth

moistened with water-diluted cleanser; then wipe again

with a dry cloth. Do not use furniture wax or cleaners.

They may damage the surface of the cabinet.

÷ Never use thinner, benzine, insecticide sprays and

other chemicals on or near the cabinets, since these

will corrode the surfaces.

÷ When a chemical cloth is used, read the cautions for

the chemical cloth carefully.

SPECIFICATIONS

Cabinet: Bass-reflex type

Used speakers (two-way system):

Woofer (for low tones) .......... 4.8 cm × 13 cm cone type

Tweeter (for high tones) ........... 2.5 cm semidome type

Nominal impedance ..................................................... 8 Ω

Frequency Range ................................ 64 Hz to 30 000 Hz

Sensitivity (1 w, 1 m) ................................................ 81 dB

Permissible input :

Max. input .............................................................. 13 W

Rated input .............................................................. 4 W

Crossover frequency ................................................ 3 kHz

External Dimensions

....................... 76.5 mm (W) × 717 mm (H) × 92 mm (D)

Weight ..................................................................... 1.7 kg

Accessory parts (for 2 speakers)

............................................................ Speaker cable × 2

...................................................... Screw (M5 × 10) × 16

............................................................................. Bracket

.............................................................. Padding strip × 2

.............................................. Operating Instructions × 1

NOTE:

Specifications and design subject to possible modification

without notice, due to improvements.

LEFT-TOP × 1

LEFT-BOTTOM × 1

RIGHT-TOP × 1

RIGHT-BOTTOM × 1

D1-4-2-6-2_En

K058_En

Published by Pioneer Corporation.